Loading ...
Loading ...
Loading ...
SECTION5: OPERATION
WARNING
AVOIDSERIOUSINJURYORDEATH
• GO UP AND DOWN SLOPES, NOT ACROSS.
• AVOID SUDDEN TURNS.
• DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR
TIR
• IF MACHINE STOPS GOING UPHILL, STOP BLADE(S) AND
BACK DOWNHILL SLOWLY.
• DO NOT MOW WHEN CHILDREN OR OTHERS ARE
AROUND.
• NEVER CARRY CHILDREN, EVEN WITH BLADES OFE
• LOOK DOWN AND BEHIND BEFORE AND WHILE BACKING.
• KEEP SAFETY DEVICES (GUARDS, SHIELDS, AND
SWITCHES) IN PLACE AND WORKING.
• REMOVE OBJECTS THAT COULD BE THROWN BY THE
BLADE(S).
• KNOW LOCATION AND FUNCTION OF ALL CONTROLS.
• BE SURE BLADE(S) AND ENGINE ARE STOPPED BEFORE
PLACING HANDS OR FEET NEAR BLADE(S).
• BEFORE LEAVING OPERATOR'S POSITION, DISENGAGE
BLADE(S), PLACE THE SHIFT LEVER IN NEUTRAL, ENGAGE
PARKING BRAKE, SHUT ENGINE OFF AND REMOVE KEY.
READOPERATOR'SMANUAL
SafetyInterlockSystem
,_ WARNING: Read, understand, and follow
all instructions and warnings on the machine
and in this manual before operating.
This tractor is equipped with a safety interlock system
for the protection of the operator. If the interlock system
should ever malfunction, do not operate the tractor.
Contact an authorized MTD service dealer. The safety
interlock system prevents the engine from cranking or
starting unless the parking brake is engaged, and the
PTO (blade engage) lever is in the disengaged
(BLADES STOP) position.
• The engine will automatically shut off if the operator
leaves the seat before engaging the parking brake.
• The engine will automatically shut off if the operator
leaves the tractor's seat with the PTO (blade
engage) lever in ANY position other than BLADES
STOP.
• The engine will automatically shut off if the PTO
(blade engage) lever is moved out of the BLADES
STOP position with the shift lever in R (reverse).
BeforeStartingEngine
WARNING: Read, understand, and follow
all instructions and warnings on the machine
and in this manual before operating.
StartingtheEngine
WARNING: Do not operate the tractor if the
interlock system is malfunctioning. This
system was designed for your safety and
protection.
NOTE: Refer to the TRACTORSET-UPon page 8 of this
manual for Gasoline and Oil fill-up instructions.
• Insert the tractor key into the ignition switch.
• Place the PTO (blade engage) lever in the BLADES
STOP position.
• Engage the tractor's parking brake.
• Activate the choke control.
• Turn the ignition key clockwise to the START
position. After the engine starts, release the key. It
will return to the ON position.
IMPORTANT:Do NOT hold the key in the START
position for longer than ten seconds at a time. Doing so
may cause damage to your engine's electric starter.
• After the engine starts, deactivate the choke control
and place the throttle control in the FAST position.
IMPORTANT:Do NOT leave the choke control on while
operating the tractor. Doing so will result in a "rich" fuel
mixture and cause the engine to run poorly.
NOTE: If Starting problems are encountered, refer to
TROUBLESNOOTINGGUIDEon page 29.
StoppingtheEngine
WARNING: If you strike a foreign object,
stop the engine, disconnect the spark plug
wire(s) and ground against the engine.
Thoroughly inspect the machine for any
damage. Repair the damage before restarting
and operating
• If the blades are engaged, place the PTO (blade
engage) lever in the BLADES STOP position.
• Depress the clutch-brake pedal to bring the tractor
to a complete stop.
• Turn the ignition key counterclockwise to the OFF
position.
• Engage the tractor's parking brake.
• Remove the key from the ignition switch to prevent
unintended starting.
13
Loading ...
Loading ...
Loading ...