Loading ...
Loading ...
Loading ...
User Manual
28
Delete Char: Delete the previous character.
Previous Char: Move the cursor forward one character.
Next Char: Move the cursor one character back.
◆
Recall: Recall the wave file. An external storage device must be connected to use this
function. Press Enter to view the file system list, use the up and down arrow keys to select
the file to be recalled. The file type that can be recalled is a .csv file, and press Enter again
to confirm. Press the Recall key to execute the recall, and the waveform is immediately
displayed in the record table.
◆
Duration: Set the data recording time.
4.Auto Scale: Auto configuration.
The system automatically adjusts the waveform display trajectory.
5.Run/Stop: Run or stop waveform recording.
9. Remote control
9.1 USB remote control
Use the USB cable to connect the USB port on the back of the computer to the USB port on
the rear panel of the power supply. At this time, the USB connected logo is displayed on the
upper right corner of the main interface of the power supply.
Download and install the IO software from the following address:
https://www.keysight.com/main/software.jspx?ckey=2175637&lc=chi&cc=CN&nid=-11143.
0.00&id=2175637
Open the IO software, find the device, and send an instruction to see if the communication
is normal. After normal communication is obtained, SCPI commands can be used to control
the power output.
E.g:
OUTP On, (@1) Set the channel 1 output on.
Volt 5, (@1) Set the voltage of channel 1 to 5V.
Meas:volt? (@1) View the output voltage value of channel 1.
Loading ...
Loading ...
Loading ...