Loading ...
Loading ...
Loading ...
nnstaUgationinstructions
GENERAL
• See the Dimensions and Clearances section for all
rough-in and spacing dimensions,. These dimensions
must be met for safe use of your range. The location
of the electrical outlet and pipe opening (see Gas
Pipe and Electric Outlet Locations) may be adjusted
to meet specific requirements.
oThe range may be placed with 0" clearance (flush)
at the back wall and side walls of the range.
LOCATION
Do not locate the range where it may be subject to
strong drafts. Any openings in the floor or wall behind
the range should be sealed. Make sure the openings
around the base of the range that supply fresh air for
combustion and ventilation are not obstructed by car-
peting or woodwork.
PROTECT YOUR FLOOR
Your range, like many other household items, is heavy
and can settle into soft floor coverings such as cush-
ioned vinyl or carpeting. Use care when moving the
range on this type of flooring° it is recommended that
the following simple and inexpensive instructions be
followed to protect your floor..
The range should be installed on a sheet of plywood
(or similar material)., When the floor covering ends at
the front of the range, the area that the range wilt rest
on should be built up with plywood to the same level
or higher than the floor covering, This will allow the
range to be moved for cleaning or servicing,
MODEL AND SERIAL NUMBER LOCATION
Depending on your range, you'll find the model and
serial numbers on a label on the front frame of the
range, behind the storage drawer, broiler drawer or
kick panel.
TOOLS YOU WiLL NEED
• Phillips and flat-blade screwdrivers
• Pencil and ruler
° Two pipe wrenches (one for backup)
o 1%" open-end or adjustable wrench
• Nut drivers or wrenches: 3/16" and 1/4"
ADDITIONAL MATERIALS YOU MAY NEED
- Gas line shut-off valve
° Pipe joint sealant or UL-approved pipe thread tape
with Teflon* that resists action of natural and LP
gases
. Flexible metal appliance connector (1/2" I.D,). A 5-
foot length is recommended for ease of installation
but other lengths are acceptable° Never use an old
connector when installing a new range.
o Flare union adapter for connection to gas supply fine
(3/4" or 1/2" NPT x 1/2" !,,D,)
° Flare union adapter for connection to pressure regu-
lator on range (t/2" NPT x 1/2" IoD,)
"Teflon: Registered trademark of DuPont
PREPARATION
• Remove all tape and packaging. Lift up the cooktop
(on models with dual burners) and remove any pack-
ing material under it.. Make sure the dual burners are
properly seated and level.
. Remove plastic film that covers some chrome parts
(around oven door, side trim)_
° Take the accessory pack out of the oven..
• Check to be sure that no range parts have come
loose during shipping.
4
Loading ...
Loading ...
Loading ...