Kenmore 3627361890 gas range

USE CARE SAFETY MANUAL - Page 12

For 3627361890. Also, The document are for others Kenmore models: 36273618*, 36273611*, 36273619*, 36273915*, 36273919*

PDF File Manual, 48 pages, Read Online | Download pdf file

3627361890 photo
Loading ...
Loading ...
Loading ...
mnstaaRationQnstructions (cont n ed)
Step 9
Installing the Anti-Tap Device
WARNING:
Range must be secured with an approved Anti-
Tip device.
. Unless properly installed, the range could be
tipped by an adult or a child standing, sitting or
leaning on an open door or drawer_
After installing the Anti-Tip device, make sure it
is in place by carefully attempting to tilt the
range forward,,
o This range has been designed to meet all rec-
ognized industry tip standards for all normal
condition&
o The use of this device does not preclude tip-
ping of the range when not properly installed,,
. If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB02X7909.
1. Mark the wall where the RIGHT EDGE of the range
is to be located° Be sure to allow for the countertop
overhang if you intend to install the range next to
cabinets,,
!
Anti-Tip I
IOev ooI
/ 2W' / o"1_kaedeEdge
J
2. Locate the outside edge of the device 2W' toward
the center of the range from the marked edge of the
range
3. Using the device as a template, mark the position of
the hote for the screw
Wallboard
Anti-Tip
Device
Wood Screw
Back of
Range
4_
5_
For wood construction, drill a pilot hole at an angle
of 20 degrees from the horizontal. A nail or awl may
be used if a drill is not available°
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you wilt need
a 1/4" x 1½" lag bolt and a 1/2" O.Do sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware,
Install the sleeve anchor into the drilled hole and
then install the lag bolt through the device. The
bolts must be properly tightened as recommended
for the hardware_
Slide the range against the walt, and check for
proper installation by grasping the front edges of
the rear surface unit openings and carefully
attempting to tilt the range forward.
WHEN ALL HOOKUPS ARE COMPLETED
MAKE SURE ALL CONTROLS ARE LEFT IN
THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
12
Loading ...
Loading ...
Loading ...