Loading ...
Loading ...
Loading ...
Network Camera User Manual
40
5. Set sensitivity.
Sensitivity
It stands for the percentage of the body part of an acceptable target
that goes across the pre-defined region. Sensitivity = 100 - S1/ST ×
100. S1 stands for the target body part that goes across the
pre-defined region. ST stands for the complete target body. The
higher the value of sensitivity is, the more easily the alarm can be
triggered.
Figure 6-5 Set Rule
6. Optional: You can set the parameters of multiple areas by repeating the above steps.
7. For the arming schedule settings, refer to Set Arming Schedule. For the linkage method settings,
refer to Linkage Method Settings.
8. Click Save.
6.2.5 Set Region Exiting Detection
It is used to detect objects exiting from a pre-defined virtual region. If it occurs, the device can
take linkage actions.
Steps
1. Go to Configuration → Event → Smart Event → Region Exiting Detection
2. Select Channel No.
3. Check Enable.
4. Select one Region. For the detection region settings, refer to Draw Area.
5. Set sensitivity.
Sensitivity
It stands for the percentage of the body part of an acceptable target
Loading ...
Loading ...
Loading ...