Loading ...
Loading ...
Loading ...
q sing and Caring for Your Cooktop
3. Hold the surface unit as level as possible
with the terminal just started into the
receptacle. Push the surface unit termi- '
hal into the receptacle.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit oppo-
site the receptacle.
NOTE: Reflector bowls reflect heat back to the cookware on the surface units. They also help
catch spills. When they are kept clean, they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of your cookware may not be flat enough, or some
may be too large for the surface unit. In either case, some of the heat that is meant to go into
or around cookware goes down and heats the reflector bowl. This extra heat can discolor it.
Cleaning under the lift-up cooktop
1. Lift front of cooktop at both front corners
until the support rods lock into place.
2. Wipe with warm, soapy water. Use a soapy
steel-wool pad on heavily soiled areas.
3. To lower the cooktop, lift cooktop from
both sides while pushing the support
rods back to unlock them. Lower the
cooktop into place.
Cleaning your cooktop
PART WHAT TO USE HOW TO CLEAN
Coil element No cleaning required • Spatters or spills will burn off,
surface units • Do not immerse in water.
Porcelain-enamel
reflector bowls
Cooktop
surface
Nonabrasive, plastic
scrubbing pad and
warm, soapy water
Sponge and warm,
soapy water
• Wipe off excess spills.
• Wash, rinse, and dry thoroughly.
• Do not put in oven during the
self-cleaning cycle.
• Wash, wipe with clean water, and
dry thoroughly.
• Use nonabrasive, plastic scrubbing
pad on heavily soiled areas.
• Do not use abrasive or harsh
cleansers. They may damage the
finish.
NOTE: Do not allow foods containing acids
(such as vinegar, tomato, or lemon juice) to
remain on surface. Acids may remove the
glossy finish. Also wipe up milk or egg
spills when cooktop is cool.
16
Loading ...
Loading ...
Loading ...