Loading ...
Loading ...
Loading ...
45
WASHER CONTROLS AND SETTINGS
Stain Treatment Options
(on select models)
Your washer is equipped with powerful stain
treatment tools. Depending on your model,
use one of the options below to deal with
tough stains on your garments. See step 5
in the
Operating the Washer
section in this
manual for details on adding stain additives
to the dispenser.
StainTreat (7300 series)
Select this option to add a short initial wash
period to available cycles using the stain
treatment additives in the stain soak/treat
compartment. After the stain wash phase,
the load will automatically advance to the
main wash cycle.
StainSoak (7600 series)
Press the Stain Soak button to select the
option, then press the Stain soak button
again to choose one of the following
described stain types. During the wash cycle,
stain treatment and detergent circulate during
the agitating load for approximately 20
minutes. SmartBoost pump technology mixes
the stain treatment and detergent before the
washer advances to the main wash cycle.
• Any Stain
Recirculating wash solution will be
heated by boost heater.
• Blood
Recirculating wash solution will NOT
be heated by boost heater to prevent
setting blood stains.
• Chocolate
Stain wash time is extended with
additional heating by boost heater.
perfect steam
TM
(on select models)
Select this option to add approximately 20
minutes of tumbling in steam.
IMPORTANT
• If steam is selected, rinse temperatures
will be elevated.
• If the wash cycle is paused or canceled
during a steam cycle, the door will
remain locked until it cools. You may
manually perform a rinse & spin cycle
to cool the internal temperature sooner.
• During a steam cycle, steam exiting
from the rear vent of the washer is
normal and not cause for alarm.
PODS® is a registered trademark of Procter
& Gamble Company, Cincinnati OH, used
under license by Electrolux.
NOTE
• Steam may not necessarily be visible
inside drum during a steam wash cycle.
• Steam may not be present during entire
steam wash cycle.
Wash Cycle Options
extra rinse (on select models)
Use this option when additional rinsing is
desired to remove excess dirt and detergent. It
is recommended for heavily soiled loads or if
household members have sensitive skin.
pure rinse (on select models)
Use this option to reduce detergent residues
and fragrances that can irritate skin which
rinses cleaner than the extra rinse cycle.
extended refresh (on select models)
Select extended refresh if you will be unable
to remove the load right after the cycle is
complete. The washer recognizes the load
has sat too long and will do a rinse and spin
to keep the load fresh for up to 12 hours.
When you are ready to remove the load
during the extended refresh segment, you
must press power to end the cycle and open
the door.
PODS
®
(on select models)
Select this option when using a detergent
pack in a model equipped with a PODS
®
button (on select dispenser only). This option
will divert the flow of water to the detergent
pack compartment optimizing the detergent
pack performance.
Loading ...
Loading ...
Loading ...