Loading ...
Loading ...
Loading ...
34
4. While supporting the door with one
hand, pinch the tabs to release the
plastic terminal cap from the hinge plate.
5. Set the door face down on a flat
surface protected by soft cloth or towel.
6. Release wiring harness from retainer
on plastic terminal cap.
IMPORTANT
Take care not to pull the door away from
the washer until you remove the wiring
harness terminal cap.
7. Then release terminal from terminal
cap. Save the cap to reinstall later.
2
1
Removing Washer Door Lock and
Plastic Hole Cover
1. Locate and remove both screws from
door lock. Save screws for later.
2. Rotate the lock as you pull it out
through the front panel. Take care not
to pull too hard or too far as the lock is
still attached to the wiring harness.
3. Disconnect the wiring harness
terminal from the door lock. Set the
door lock aside for re-installation later.
4. Pry the bottom of the plastic hole
cover upward to release it from the
front panel. You may have to use a
non-scratching plastic knife if you are
unable to release it manually. Then,
slide the cover down slightly and
remove it from the front panel.
x2
1
Remove coarse thread screw
2. Insert wiring harness into door lock.
3. Insert door lock into front panel and
reinstall door lock screws.
1
2
3
Reinstall coarse thread screw
Reinstalling Washer Door Lock
and Hole Cover
1. Move the plastic cover to the other side
of the front panel. Position the cover so
the “hook” is at the bottom. Insert hook
into lower slot, slide the cover down,
and press upper retention tabs into
opening until they snap into place.
2
1
INSTALLATION
Loading ...
Loading ...
Loading ...