Loading ...
Loading ...
Loading ...
30
WARNING
Adjustments to the gas burner should
only be performed by qualified service
personnel.
9. Follow manufacturer’s guidelines for firmly
securing the strain relief and power cord.
10. Reinstall the terminal block cover.
3
21
WARNING
ELECTRICAL SHOCK HAZARD
DO NOT make a sharp bend or crimp
wiring/conductor at connections.
1. 30 AMP NEMA 14-30
2. Ground (GREEN wire)
3. Neutral (WHITE wire)
NOTE
If a terminal screw falls during cord
installation, it can be retrieved in the
terminal screw recovery slot below the
access panel.
1
2
3
4
5
6
7
8
1. Internal ground (WHITE) initial location.
2. Move (WHITE) wire to neutral (SILVER)
terminal for 4-wire system).
3. Neutral (SILVER Terminal)
4. WHITE neutral wire
5. BLACK or RED power wire
6. BLACK or RED power wire
7. GREEN ground wire
8. GREEN Ground screw
Connecting the Gas
This gas laundry center comes from the factory
with natural gas burner components installed.
DO NOT operate this gas laundry center, using
LP (liquid propane) gas, unless the LP gas
conversion kit has been properly installed by
a qualified service personnel. Improper gas
installation or LP conversion kit installation
could result in injury or even death.
1. Remove the shipping cap from gas
pipe at the rear of the laundry center.
All connections must be wrench-tightened
1. Valve open position
2. Valve closed position
3. Manual Shutoff valve
4. Flare union
5. Gas flow
6. Flare union
7. Nipple
8. Flexible connector
9. Inlet pipe on back of laundry center
2. Connect a 1/2 inch (1.27 cm) I.D.
semi-rigid or approved pipe from
gas supply line to the 3/8 inch (0.96
cm) pipe located on the back of the
laundry center. Use a 1/2 inch to 3/8
inch (1.27 cm to 0.96 cm) reducer for the
connection. Apply an approved thread
sealer that is resistant to the corrosive
action of liquefied gases on all pipe
connections.
1
7
5
98
1
2
7 8 9
5
643
WARNING
DO NOT connect the laundry center to
L.P. gas service without converting the gas
valve. An L.P. conversion kit PN# PCK4200
(not included) must be installed by a
qualified gas technician.
INSTALLATION
Loading ...
Loading ...
Loading ...