Loading ...
Loading ...
Loading ...
35
INSTALLATION
Connect to Notches
3. Make sure the alignment tabs reengage.
4. Reattach the inner door
to the outer door using
the nine screws removed
earlier. See illustration,
Step 1.
5. Check to verify that the
scoop (wider section) of
the door bowl is situated at
the BOTTOM of the door.
Reversing Washer Door Assembly
1. Locate nine screws on inner door
ring. Remove each and save for re-
installation later. Remove inner door
(with hinge) and carefully set aside.
2. Lift door bowl slightly and rotate 180
degrees, setting it back onto outer door.
Reinstalling Washer Door Assembly
1. Insert the wiring harness terminal into
the terminal cap and wrap the harness
into the harness retainer.
2. Slide terminal cap onto back of hinge
plate until tabs snap into place.
3. Insert hinge locating pins into the hole
that were previously covered by the
plastic hole cover. Press on the face of
the hinge to snap the other locating
pins into place.
x4
1
2
3
4
5
4. Reinstall all four screws removed earlier
- two front screws first, then two side
screws.
Reinstall fine thread screw
Loading ...
Loading ...
Loading ...