Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
Samsung works hard to ensure that you don't have problems with your new electric range. If you run into
unexpected trouble, look first for a solution in the table below. If, after trying the suggested solution, you're
still having trouble, call Samsung at 1-800-SAMSUNG (1-800-726-7864).
PROBLEM POSSIBLECAUSE
The range is not The appliance has been installed
level, improperly.
The floor is sagging or sloping.
The kitchen cabinets are not
properly aligned and make the
range appear to be not level.
¸I
,, Place the oven rack in the center of the
oven. Place a level on the oven rack.
Adjust the leveling legs at the base of the
range until the oven rack is level.
Insure the floor is level and strong and
stable enough to adequately support the
range.
,, Contact a carpenter to correct the situation.
Insure the cabinets are square and provide
sufficient room for installation.
The appliance The kitchen cabinets are not ,, Contact a builder or installer to make the
must be accessed square and built too tightly in to the appliance accessible.
for servicing and appliance.
cannot be moved Carpet is interfering with ,, Provide sufficient space so the range can
easily, movement of the range, be lifted over the carpet.
The oven control You have a function error code. • Press OVEN OFF and restart the oven.
beeps and displays If the problem persists, disconnect all
an error code. power to the range for at least 30 seconds
E-21 Oven sensor opened
and then reconnect the power. If this does
E-22 Oven sensor shorted not solve the problem, call for service.
Oven heating over
Temp probe error
E-OE Door locking error
E-83 Communication error
Communication error
(Touch)
-dE- Divider error
The surface units You may be using inappropriate ,, Use pans which are flat and match the
will not maintain cookware, diameter of the surface unit selected.
a rolling boil or In some areas, the power (voltage) ,, Cover the pan with a lid until the desired
will not cook fast may be low. heat is obtained.
enough.
The surface units A fuse in your home may be blown * Replace the fuse or reset the circuit
will not turn on. or the circuit breaker tripped, breaker.
The eooktop controls are set * Check to see the correct control is set for
_mproperly. the surface unit you are using.
The surface unit This is normal. The unit is still on and hot.
stops glowing when
changed to a lower
setting.
English - 74
Loading ...
Loading ...
Loading ...