Loading ...
Loading ...
Loading ...
6
Questions? We’re here to help!
Visit: www.maxi-matic.com for support on this product.
HOW TO USE
1. Make sure that the motor unit is disconnected from the
power socket.
2. Add the ingredients that you wish to blend into the
blending jar. The maximum amount of ingredients that can
be put into the blending jar is marked by the MAX mark.
Do not overll the blending jar with food or liquids.
3. Assemble the blending jar according to the instructions in
the section “ASSEMBLING AND DISASSEMBLING.” Turn the
assembled blending jar over so that the blade assembly
points downwards and insert it into the motor unit so that
the tabs along the outer perimeter of the blending bottle
slide into the slots on the motor unit.
4. Connect the motor unit to a
power socket. To start the
blender, rotate the assembled
blending jar clockwise and then
select your chosen program.
The blender is equipped with
a safety mechanism that will prevent
it from being started unless the blending jar assembly is
properly attached to the motor unit.
5. If ingredients are getting stuck on the blade assembly
or on the walls of the blending jar, turn the blender off
by pressing the STOP button. Make sure that the blade
assembly has stopped rotating. Take the blending jar
assembly off the motor unit and turn it over so that the
blade assembly points upwards. Screw off the blade
assembly. Use a plastic spatula to clean the blade assembly
and the walls of the blending jar. Reassemble the blending
jar and insert it back into the motor unit. Plug the power
cord into a power socket, turn the blending jar clockwise
and select your chosen program and continue blending.
6. To nish blending, press the STOP button and rotate the
blending jar counter-clockwise. Press ”o“ to power OFF the
blender. Disconnect the power cord from the power
socket. Check that the blade assembly has stopped
rotating and take the blending jar assembly off the motor
unit.
7. Turn the blending jar over so that the blade assembly
points upwards. Take off the blade assembly and as
required, close the blending jar with the cap or pour its
contents into another suitable container.
CAUTION:
Allow hot liquids and
foodstuffs to cool
down to a temperature
of at least 45°C before
putting them into
the blending jar and
blending them.
The maximum
operating time is 1
minute. Do not leave
the appliance in
continuous operation
for longer. Allow the
appliance to cool
down for 3 minutes.
When processing dry
ingredients, do not
leave the appliance in
continuous operation
for longer than 30
seconds.
NOTE:
Some liquids gain
volume during the
blending process.
There is a power
switch located near
the back right side
of the blender. Press
”-“ to power ON the
blender.
To close the bottle
you may use the
cap. Always properly
tighten the cap to
prevent the bottle’s
contents from leaking
out. When using cap,
make sure that the
drinking spout is
properly closed so as
not to spill the bottle’s
contents when carry-
ing it.
-
-
-
-
-
-
Loading ...
Loading ...
Loading ...