Loading ...
Loading ...
Loading ...
ASSEMBLY
TO CHECK/ADJUST CLUTCH
CONTROL CABLE
The control cable, FIG. 6, attached to the auger clutch
lever may need to be adjustedbefore you use your snow
thrower.
Forinstructionson checkingoradjusting thecontrol cable,
(See To Adjust Clutch Control Cable paragraph on
page 17).
TO ASSEMBLE SNOW CHUTE
• Turn crank assembly counterclockwise until it stops.
• Remove three carriage bolts, flat washers, and nuts
from snow chute flange. DO NOT remove carriage
bolt over worm gear (See FIG. 7).
• Position snow chute on snow chute flange and alJgn
the three holes in the snow chute with holes in the
snow chute flange (See FIG. 7A).
• Replacecarriage bolts from inside of chute as shown
in FIG. 7A, flat washers, and nuts.
• Tighten all four carriage boltssecurely.
NOTE: Ifsnowchute isfacingtheoperatorit isassembled
incorrectly. Check assembly instructions.
,f CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
SNOW THROWER, WE WISH TO ASSURE THAT YOU
RECEIVE THE BEST PERFORMANCE AND
SATISFACTION FROM THIS QUALITY PRODUCT.
PLEASE REVIEW THE FOLLOWING CHECKLIST:
4' Atl assembly instructions have been completed.
/ The discharge chute rotates freely.
/ No remaining loose parts in carton.
WHILE LEARNING HOW TO USE YOUR SNOW THROWER,
PAY EXTRA ATTENTION TO THE FOLLOWING IMPOR-
TANT ITEMS:
/#" Engine oil isat proper lever.
/,/' Make sure gas tank is filledproperly with clean, fresh, un-
leaded gasoline.
J/ Become familiar with all controEs-their location and
function. Operate controls before starting engine.
DO NOT
REMOVE
WOR M
GEAR
AUGER CLUTCH LEVER
/_
1
/ /
CONTROL CABLES
FIG. 6
REMOVE
FIG. 7
LOCKNUT
iSHER
: SNOW CHUTE
_E ,o..,.jNOWCHUTEFLANGE
FIG. 7A
9
Loading ...
Loading ...
Loading ...