Loading ...
Loading ...
Loading ...
TRUE RESIDENTIAL
®
TEC_TM_156 | REV. D | EN9/12/2022Page 82 of 96
MAINTENANCE, CARE & CLEANING
CONDENSER COIL CLEANING
CAUTION – TAKE CARE DURING OPERATION, MAINTENANCE, OR REPAIRS TO AVOID CUTS OR PINCHING
FROM ANY CABINET PART/COMPONENT.
ATTENTION – LORS DE L’UTILISATION, DE L’ENTRETIEN OU DES RÉPARATIONS, IL FAUT PRENDRE SOIN
D’ÉVITER LES COUPURES ET LES PINCEMENTS POUVANT SURVENIR AU CONTACT DES PIÈCES OU DES
COMPOSANTES DE L’ARMOIRE.
Keeping the condenser coil clean minimizes required
servicing and lowers electrical cost. Warranty does not
cover cleaning the condenser coil.
WARNING – Electrical shock or burn
hazard. Unplug the unit or turn off the
power supply before proceeding. DO
NOT clean appliance with a pressure
washer or hose.
ATTENTION – Risque d’électrocution ou
de brûlure. Débranchez l’appareil ou
coupez l’alimentation électrique avant
de continuer. Ne nettoyez pas l’appareil
avec un nettoyeur haute pression ou un
tuyau.
CAUTION – Risk of eye injury from
debris. Eye protection is recommended.
ATTENTION – Les ailettes sont
coupantes. Soyez prudent pour éviter
les lésions oculaires. Une protection des
yeux est recommandée.
CAUTION – Coil fins are sharp. Gloves are
recommended.
ATTENTION – Les ailettes de la bobine
sont tranchantes. Les gants sont
recommandés.
REQUIRED TOOLS
Required tools include (but may not be limited to)
the following:
• Gloves
• Eye Protection
• Stiff Bristle Brush
• Vacuum Cleaner
• Flashlight
• Tank of Compressed Air
PROCEDURE
1. Remove the kickplate. See fig. 1.
2. With a stiff bristle brush, carefully clean
accumulated dirt from the front coil fins. See fig. 2.
3. With the dirt removed from the surface of the coil,
use a flashlight to verify you can see through the
coil and observe the condenser fan blade spinning.
See fig. 3.
4. If the view is clear, reinstall the kickplate, restore
power, and verify correct operation.
5. If the view is not clear, gently blow compressed air
or CO
2
through the coil until it is clean.
6. Carefully vacuum any dirt around the condensing
unit area.
7. Reinstall the kickplate, restore power, and verify
correct operation.
Loading ...
Loading ...
Loading ...