Loading ...
Loading ...
Loading ...
15
Installation
Removing door assembly
1. Completely open the door to expose
all four hinge screws.
2. Remove all four hinge screws with #2
square bit driver. Save for reinstalling
later.
3. Hold the door with one hand
supporting the handle area and one
hand supporting the hinge. While
supporting the door at the hinge, press
firmly with the other hand until the
locating pins on the back of the hinge
plate dislocate from the front panel.
4. While supporting the door with one
hand, pinch the tabs to release the
plastic terminal cap from the hinge
plate.
5. Set the door face down on a flat
surface protected by soft cloth or
towel.
x4
Fine Thread
Plastic knife
Screwdriver
with #2
square bit
Tools needed for reversal:
NOTE
Door reversibility is available only on 400, 500, or 600 series models.
IMPORTANT
BEFORE YOU REVERSE WASHER DOOR:
1. Be sure you have adequate swing area before
reversing door.
2. Gather your tools - including a screw driver with a
#2 square bit and plastic knife (or small, flat prying
tool that won’t damage paint).
3. Protect flat work surface, such as top of washer
or floor near washer, with a soft cloth or towel.
4. Be sure washer is unplugged from power source!
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could result in personal injury or
even death.
IMPORTANT
Take care not to pull the door away from
the washer until you remove the wiring
harness terminal cap.
Reversing the door
Loading ...
Loading ...
Loading ...