Loading ...
Loading ...
Loading ...
14
6. Tighten by
hand until snug.
Then tighten
each supply
connection
another 2/3
turn with pliers. Do not bend, kink or
pinch water inlet hoses.
7. Turn on the water
and check for
leaks.
Anti-Siphon
Disc
1. Verify the anti-
siphon disc is
in place.
Connecting the drain
1. Plug the power cord into a grounded
outlet.
2. Turn on the power at a circuit breaker/
fuse box.
3. Carefully slide the washer to its final
position. Recheck for level and rock
corners for stability.
See Leveling the
washer.
Remove and discard door
tape.
4. Run the washer through a complete
cycle, checking for water leaks and
proper operation.
5. If you have any questions during
initial operation, please review the
“Troubleshooting” section before
calling for service.
6. Place these instructions in a location
near the washer for future reference.
Installation
Insert Less
Than 8.5"
(21.5 cm)
Cable Tie
NOTE
The standpipe inside diameter must be
1-1/4” (3.2 cm) minimum. There must be
an air gap around the drain hose in the
standpipe. A snug hose fit can cause a
siphoning action.
NOTE
A wiring diagram and technical data
sheet are located under the washer top
panel, on top of the detergent dispenser
housing.
IMPORTANT
Check to ensure the power is off at a
circuit breaker/fuse box before plugging
the power cord into an outlet.
2. Form a “U”
shape on the
end of the drain
hose with the
hose pointed
toward the
drain. Place
the formed end in a laundry tub or a
standpipe and secure the drain hose
with the cable tie (provided in the
enclosure package) to the standpipe,
inlet hose, laundry tub, etc. so the
hose does not pull out from the force
of the water.
WARNING
ELECTRICAL SHOCK HAZARD
Improper connection of the equipment
grounding conductor can cause an elec-
trical shock that may result in serious inju-
ry or death. Check with a licensed electri-
cian if you are in doubt as to whether the
appliance is properly grounded.
See
Electrical System Requirements
and
Grounding Requirements
sections of this
instruction for additional information.
Completing the
installation
Loading ...
Loading ...
Loading ...