User Manual - Page 171

For 2022 JEEP WRANGLER 4XE.

Loading ...
Loading ...
Loading ...
170 STARTING AND OPERATING
To disconnect the stabilizer/sway bar, shift to
either 4H or 4L and push the SWAY BAR switch to
obtain the off-road position Ú page 163. The Sway
Bar Indicator Light will flash until the stabilizer/
sway bar has been fully disconnected.
NOTE:
The stabilizer/sway bar may be torque locked due
to left and right suspension height differences.
This condition is due to driving surface differences
or vehicle loading. In order for the stabilizer/sway
bar to disconnect/reconnect, the right and left
halves of the bar must be aligned. This alignment
may require that the vehicle be driven onto level
ground or rocked from side to side.
To return to on-road mode, push the SWAY BAR
switch again.
OFF ROAD+ IF EQUIPPED
OFF ROAD+ Switch
When activated, Off Road+ is designed to improve
the user experience when using specific Off Road
driving modes. To activate Off Road+, push the
OFF ROAD+ switch in the switch bank. The
vehicle’s performance will improve depending on
which Four-Wheel Drive (4WD) mode is activated.
NOTE:
Off Road+ will not function in 2H mode. If the
button is pushed while in 2H mode, the cluster
display will show the message “Off Road+
Unavailable Shift to 4WD”.
When Off Road+ is active, the following features
will activate:
The Off Road+ telltale will illuminate in the
instrument cluster display
A mode-specific message will display the instru-
ment cluster display
Off-Road Pages will launch on the radio
head-unit if selected in radio settings
The Off-Road Camera will launch if selected in
radio settings
Once in Off Road+, the vehicle will begin to behave
in different ways depending on the 4WD mode in
use. The following enhancements will occur when
using Off Road+.
WARNING!
Ensure the stabilizer/sway bar is reconnected
before driving on hard surfaced roads or at
speeds above 18 mph (29 km/h); a
disconnected stabilizer/sway bar may
contribute to the loss of vehicle control, which
could result in serious injury. Under certain
circumstances, the front stabilizer/sway bar
enhances vehicle stability and assists with
vehicle control. The system monitors vehicle
speed and will attempt to reconnect the
stabilizer/sway bar at speeds over 18 mph
(29 km/h). This is indicated by a flashing or
solid Sway Bar Indicator Light. Once vehicle
speed is reduced below 14 mph (22 km/h), the
system will once again attempt to return to
off-road mode.
WARNING!
If the stabilizer/sway bar will not return to
on-road mode, the Sway Bar Indicator Light will
flash in the instrument cluster and vehicle
stability may be reduced. Do not attempt to drive
the vehicle over 18 mph (29 km/h). Driving
faster than 18 mph (29 km/h) with a
disconnected stabilizer/sway bar may contribute
to the loss of vehicle control, which could result
in serious injury.
22_JL_OM_EN_USC_t.book Page 170
Loading ...
Loading ...
Loading ...