Loading ...
Loading ...
Loading ...
w_oBEFORE USING THE SURFACE BURNERS, make sure to follow all the safety
warnings and precautions listed on page 8. Failure to do so could result in product
damage, personal injury, and/or death.
LIGHTING A GAS SURFACE BURNER
Make sure all surface burners are positioned and
assembled properly.
1. Push in and turn the control knob to the LITE
position. You will hear a "clicking" sound
indicating the electronic ignition system is
working properly.
2. After the surface burner lights, turn the control
knob to adjust the power setting of the surface
burner and turn off the electronic ignition system.
3. The dual valve located in the farthest to the right controls the inner/outer flame of the
dual burner[RF].
When the inner / outer flame is on the HI position, the flame size
gets smaller from the outside when turning the knob from HI to LO.
To control the inner flame, push and turn the knob once again at
the position where it starts to control inner flame.
We highly recommend using the right front side burner for
simmering tomato sauce and right rear side burner for melting
chocolate
MANUALLY LIGHTING A GAS SURFACE BURNER
if a power failure occurs, the surface burners can still be lit manually.
_Use extreme caution when manually lighting a surface burner.
1. Hold a long gas grill lighter to the surface burner you want to light.
2. Push in and turn the control knob for that burner to the LITE position.
3. After the burner has lit, set the control knob and the burner to the desired setting.
FLAME SIZE SELECTION
/_ Flames larger than the bottom of the cookware will not result in faster heating, but
wA%'_,,,could result in a fire hazard and/or personal injury.
The flames on the burners should always stay under the cookware. The flames should
never extend beyond the bottom surface and/or up the sides of the cookware.
Always watch the flames when adjusting the heat setting with the control knob(s). The
flames should always match the size of the cookware being used.
surface cooking 21
Loading ...
Loading ...
Loading ...