Loading ...
Loading ...
Loading ...
ToAdd,Repmgramor Changea Key/essEntryPIN
NOTE: Yournew KeytessEntry must beprogrammed to operateyour garage door opener,
USING THE "LEARN" BUTTON USING THE MULTI-FUNCTION DOOR CONTROL
t, Pressand releasethe "learn" J_ j .................
button on motor unit, Thelearn LL_._ (0)-'_
indicator fight will glow steadiiy J [T--mRI_ I I I
2. Withfn 30 seconds, entera four
digit personal identification
number (PIN) of your choice
on the keypad.Then press and
hold the ENTERbutton.
3. Releasethe button when the
motor unit lights blink. It has
learned thecode. if light bulbs
are not installed, two clicks will
beheard.
.,.I /
Tochange an existing, known PIN
If the existing PiN is known, it may bechanged by one
person without usinga ladder.
1. Pressthe four buttons for the present PIN,then press
and hold the# button.
The opener light will blink twice, Releasethe # button.
2. Pressthe new4-digit PiN you havechosen, then
press ENTER.
The motor unil lights will biink once when the PIN has
beenlearned.
Test by pressing the newPiN, then press ENTER.The door
sboutd move.
Toset a temporary PIN
You may authorize access by visitors or service people
with a temporary 4-digit PIN. After a programmed number
of hours or number of accesses, this temporary PiN
expires and wilt no longer open the door. it can be used
to close the door evenafter it hasexpired. To set a
temporary PiN:
t. Press the four buttons for your personal entry PIN (not
the last temporary PIN), then press and hold
the .!_button.
The opener tight will blink three times. Releasethe button.
NOTE: Thismethod requires two people it the Keytess
Entry is already mounted outside the garage.
Entera four digit personal
identification number (PIN) of
your choice on the keypad. Then
press and hold ENTER.
2Whehodn theENTER
button, press and hold the
LIGHTbutton on the Multi-
Function door control.
and LIGHTbuttons wtlile you
press the push bar on the Multi-
Function door controt (all three
buttons are held).
4. Release buttons whenthe motor J
unitIights blink. It hasiearned J --. [ /
the code. If light bulbs are not J
2. Pressthe temporary 4-digit PINyou havechosen,then
press ENTER.
The opener light will biink four times.
3. To set the number of floursthis temporary PIN will
work, press the number of hours (up to 255), then
press *.
OR
3. To set the number or times this temporary"PIN will
work, press the number of times (up to 255), then
press #.
The opener light wili blink once whenthe temporary PIN
has been learned.
Testby pressing the four buttons for the temporary
PIN, then press ENTER.The door should move. II the
temporary PIN was set to acertain number of openings,
remember that thetest has used up one opening.To clear
lhe temporary password, repeatsteps I-3, setting the
number of hours or times to Oin step 3.
OneButton Close:Opener can be closed by pressing only the ENTERbutton if the onebutton close feature has been
activated. This featurehas been activatedat the factory. To activate or deactivate this feature press and ho_dbuttons 1
and 9 for 10 seconds. The keypadwill blink twice when theone button ciose is active. The keypadwill blink tour times
when one button close is deactivated,
38
Loading ...
Loading ...
Loading ...