Loading ...
Loading ...
Loading ...
23
INSTALL THE WARMING RACK
Note: Wear heat-resistant gloves if necessary.
The warming rack (Fig. 23-1) is packed separately. To install
the warming rack, carefully insert the rack hangers into the
two holes in the back of the inner oven hood, then lower the
front of the rack to a level position.
Note: Removing the warming rack before using the rotisserie
will leave more clearance for the meat being cooked
(if applicable).
INSTALL THE RIGID SHELVES
This grill comes with two (2) rigid shelves that must be
attached. These can be attached using the four support
screws provided and a Phillips-head screw driver.
Important: Take caution to not cross-thread when tightening
the screws.
1. Hold the shelf inverted so that one of the corner holes
in the shelf lines up with the appropriate upper screw
hole in the grill.
2. Insert the screw, but do not tighten all the way so that
the shelf can be easily rotated around the first screw.
3. Line up the second corner hole in the shelf with the
remaining upper screw hole in the grill. Insert a screw
and tighten.
Note: You may lift the edge of the shelf upward to gain
better access during much of the tightening of this
screw.
4. Finally, insert the bottom screws on the left and right side
of the shelf and securely tighten all screws.
To detach, reverse the process above.
COMMON INSTALLATION
(Cont.)
Fig. 23-2 View from under right shelf
Shelf support screws
Fig. 23-1 Install warming rack
Loading ...
Loading ...
Loading ...