Loading ...
Loading ...
Loading ...
Ignitor BatteryInstallation- SeeFig.10
1. Unscrewthe Ignitor Cap located on the grill
Control Panel and remove the Contact and
Spring from the Ignitor Slot.
2. Place the manufacturer supplied AA battery
into the Ignitor Slot. Be sure to place the
positive pole facing toward you. See Fig. 10.
3. Place the Spring over the AA battery, then
place the Contact on top of the Spring. Screw
the Ignitor Cap back onto the grill Control
Panel.
Figure 10 _--
Electrode Check - Requires an Assistant
Before placing the cooking components into your
grill, ensure that the Spark Electrode Tip is
properly positioned within each Gas Collector Box
(a 3-1/4" wide stainless mechanism found at the
front between each set of burners.) The easiest
way to ensure this is to perform the following
Electrode Check:
1. Be sure all Control Knobs are set to "OFF".
2.
Have an assistant stand behind to the right of
the grill and look down at each Gas Collector
Box. NEVER put your face inside the grill
bowl.
3. Press the Ignitor Cap and have the assistant
watch for a small blue spark within each Gas
Collector Box, If a spark is present the
Electrode Tips are properly positioned.
4. If no spark is seen the Spark Gap shown in
Fig. 11 needs to be adjusted as follows:
• Usingan adjustablewrench, loosen the InsideNut
just untilthe Gas CollectorBox can be
manueveredandturnedupward,
• The gap between the Spark Electrode Tip and
the bottom of the Gas Collector Box should
be approximately 3/16".
• Ifthe gap is widerthan 3/16" usea pair oflong
nose pliers and gentlysqueeze the Gas Collector
Box untilthe gap iscorrect.
• Returnthe Gas Collector Boxto itsoriginal
horizontalposition, secure the Inside Nut and try
the Electrode Check again.
Figure tl - Side View
GAS COLLECTOR BOX
INSIDE NUT
. 4
SPARK GAP SPARK ELECTRODE TIP
12
Loading ...
Loading ...
Loading ...