Loading ...
Loading ...
Loading ...
Operating peripheral equipment using the remote control
Programming Without A Code (When the code is not known)
This procedure searches all codes and is called the "sequence method."
®
®
®
1 Confirm that the external component is plugged in and on.
2 Turn the component off.
3
+
Press POWER and ACTION together, for at least 5
seconds.
After 5 seconds, all the illuminated mode keys will
begin to flash.
Release the POWER and ACTION key.
4 <_ _,_ Press the mode key.
0 _ _ _ ThLmode key willilluminatesteadily, all otherswillgo
Press to move forward to the next code, or to move
backward.
6
Press the Remote Control to test the component. If the procedure was
successful, the component will turn on.
Note:
Repeat the above steps until the component code is found. It may take many
attempts before the correct code is found.
After the code is found, press ACTION to store the code.
Note:
The step and set mode will start from the current device (not the beginning of the
list, except for the first time).
63
Loading ...
Loading ...
Loading ...