Loading ...
Loading ...
Loading ...
have increased. Do not reduce the pressure
of warm tires in an attempt to match the
recommended cold tire pressures.
To view the recommended COLD tire pressures
for your vehicle, select the RECOMMENDED
tab. Always inflate your tires to the pressures
recommended by Lucid, even if it is
different from the maximum inflation pressure
information found on the tire itself.
Adjusting tire pressure
The recommended COLD tire pressures are
also shown on the Tire and Loading Information
Label located on the driver's side door jamb.
Recommended Tire Inflaton Pressure depends
on the type of tires mounted on the vehicle at
the factory. The label, located on the left door
jamb between front and rear doors, provides
the Tire and Loading Information for your
vehicle.
To check and adjust tire pressures:
1. Remove the cap from the valve, then
firmly press the tire gauge onto the valve
and measure the pressure.
2. If required, add air to reach the required
pressure.
3. Check the pressure by removing the tire
gauge and then re-attaching it. Failure to
remove and re-attach the gauge to the
valve could cause the gauge to show an
incorrect reading.
4. If the tire pressure is too high, remove
the gauge and release air from the tire by
pressing on the metal stem in the center
of the valve. Refit the gauge to the valve
and check the pressure.
5. Repeat the process of adding or removing
air as required until the correct tire
pressure is reached.
6. Refit the valve cap.
Tire valves
Keep the valve caps screwed down firmly to
prevent water or dirt from entering the valve.
Check the valves for leaks when checking the
tire pressures.
Flat spots
If the vehicle is stationary for a long period
when the ambient temperature is high, the tires
may form flat spots. When the vehicle is driven,
these flat spots will cause a vibration that will
steadily disappear as the tires warm up and
regain their original shape.
Tire pressures during long-term storage
Inflate tires to the maximum pressure as
indicated on the tire wall to minimize flat spots
during storage.
WARNING: The tire pressures must be
reduced to the correct pressure before
the vehicle is driven.
Replacing Tires and Wheels
WARNING: For your safety, it is
recommended that only wheels
and tires that match the original
specification are used on the vehicle.
Specifications for approved winter tires
are available by contacting your Lucid
Service Center.
WARNING: Operation of the Tire
Pressure Monitoring System (TPMS)
may be affected if the tires are replaced
with a different specification from the
originals.
Wheel rims and tires are matched to suit
the handling characteristics of the vehicle.
Always check that replacement tires comply
with the original specification. If tires other
than those specified are used, ensure that the
load and speed ratings (shown on the tire side
wall) equal or exceed those of the original
specification.
For the specification of the original wheels and
tires installed on the vehicle, refer to
Wheel and
Tire Specifications.
Tire & Wheels 180
Loading ...
Loading ...
Loading ...