Loading ...
Loading ...
Loading ...
programming per the HomeLink website
or operator’s manual.
4. To record the remote signal, press and
hold the remote 2 in (5 cm) below the
letter L on the front of your vehicle until
the horn sounds and the headlights flash.
5. Once the Pilot Panel shows that recording
is completed, press CONTINUE.
Note: If the on-screen process detects
that your device uses a fixed code, it will
automatically skip this step and proceed
to the test in the next steps.
6. To train the receiver, press the LEARN
button on the back of your receiver
(removing the cover if needed), then press
CONTINUE on the Pilot Panel.
Note: Because pressing the LEARN
button is time-sensitive, a second person
can assist with this step.
Note: If your receiver is QuickTrain
compatible, you can press CONTINUE.
Note: After pressing the 'LEARN' or
sync button, you will have 30 seconds
to test HomeLink. If a signal is not
detected within the timeout period, an
error message will be displayed with the
option to try again.
7. To test, press the TEST HOMELINK
button. You will need to press this three
times in total. Wait until you see a check
mark before pressing the button a second
and third time.
8. During each brief test, the TEST
HOMELINK button will be temporarily
unavailable, while the current test number
animates to indicate it is in progress.
Note: The device you are programming
may respond during any of these three
tests. Continue with all three tests.
9. After a test completes, a check replaces
the number and the TEST HOMELINK
button becomes available. Continue
through all three tests.
10. After all three tests have completed, the
screen will prompt you to confirm whether
the device responded. Press
YES or NO.
Note: Pressing NO will give you the option
to restart the test and contact information
for HomeLink Help.
11. If you pressed
YES, you will be brought
back to the Connectivity screen. Your
new HomeLink device will be listed under
CONNECTED DEVICES.
Reprogramming a device
1. On the Pilot Panel, select
>
Connectivity > HomeLink, then select
the device to be reprogrammed.
2. On the device details screen, press
PROGRAM.
3. Follow the steps for programming a
device. See Programming Homelink.
Using HomeLink®
Once devices have been programmed to your
vehicle, they can be accessed using the
HomeLink menu on the right Cockpit Panel.
The HomeLink menu will open automatically
when the vehicle is detected within 82 ft (25 m)
of a programmed garage door or gate. To access
it manually:
1. Press the status bar to expand.
2. Press
to open HomeLink.
From this menu, you can:
- Press + ADD NEW HOMELINK to add a
new device. See Programming HomeLink.
- Press HOMELINK SETTINGS to edit or
remove existing devices. See Renaming or
Deleting a Device.
- Press a device name to activate it.
The icon next to a device indicates that a
signal has been sent to the door or gate. The
menu automatically collapses 3 seconds after a
signal is sent.
Renaming or Deleting a Program
Note: For your security, it is recommended to
delete all programmed devices upon the sale or
lease termination of your vehicle.
Renaming a program
1. On the Pilot Panel, select
>
Connectivity > HomeLink, then select
the device to be renamed.
Infotainment 136
Loading ...
Loading ...
Loading ...