Napoleon NZ3000H High Country Series Natural Vent Woodburning Fireplace

User Manual - Page 51

For NZ3000H.

PDF File Manual, 128 pages, Read Online | Download pdf file

NZ3000H photo
Loading ...
Loading ...
Loading ...
W415-1517 / A / 09.02.16
51
EN
If the glass is not kept clean permanent discolouration and / or
blemishes may result. Normally a hot re will clean the glass.
The most common reasons for dirty glass include: not using
suf cient fuel to get the appliance thoroughly hot, using green
or wet wood, closing the draft so far that there is insuf cient air
for complete combustion.
If it is necessary to clean the glass, buff lightly with a clean dry
cloth and non-abrasive cleaner.
DO NOT CLEAN GLASS WHEN HOT! Clean the glass after the rst 10 hours of operation with a
recommended appliance glass cleaner. Thereafter clean as required.
The glass is very strong but do not let burning fuel rest or fall against it and always close the door gently.
NEVER FORCE IT SHUT!
If the glass should ever crack or break while the re is burning, do not open the door until the re is out and do
not operate the appliance again until the glass has been replaced. Available from your Authorized dealer.
DO NOT SUBSTITUTE MATERIALS.
5.3
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
!
WARNING
Periodic inspection of the catalytic combustor is needed to ensure proper functioning of the unit and also to
determine when replacement is required. Creosote buildup, increase in emissions and a loss of heat effi ciency
will result from a non-functioning combustor unit.
Catalytic combustors should remain active under normal operating conditions for a period of six to ten years.
This will be determined by the quality and the amount of
wood burned.
THIS WOOD HEATER CONTAINS A CATALYTIC COMBUSTOR, REQUIRING PERIODIC REPLACEMENT
AND REGULAR INSPECTION FOR PROPER OPERATION. IT IS AGAINST UNITED STATES FEDERAL
REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT WITH OPERAT-
ING INSTRUCTIONS IN THIS MANUAL. THIS INCLUDES THE REMOVAL OR DEACTIVATION OF THE
CATALYTIC ELEMENT.
6.1
If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on the
plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature
but this can be improved if the assembly is warmed, using a hair dryer or similar heat source.
9.8 CARE OF GLASS
9.9 CARE OF CATALYST
9.10 CARE OF PLATED PARTS
Loading ...
Loading ...
Loading ...