Loading ...
Loading ...
Loading ...
SET TEMPERATURE｣ｨ
O
C)
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
TEMP.
MODE
ON/OFF
FAN SPEED
SWING
ECONOMIC
TIMER ON
RESET
LOCK
TIMER OFF
AIR DIRECTION
POWERFUL
3. ACCESSORIES
Please check whether the following fittings are in scope. If there are some spare fittings , please restore them carefully.
Fig.3-1
Never throw or beat the controller.
Before installation, operate the remote controller to determine its location in a
reception range.
Keep the remote controller at least 3.28ft (1m) apart from the nearest TV set or
stereo equipment. (it is necessary to prevent image disturbances or noise
interferences.)
Do not install the remote controller in a place exposed to direct sunlight or close to a
heating source, such as a stove.
Note that the positive and negative poles are right positions when loading batteries.
This manual is subject to changes due to technological improvement without further
notices.
Cautions on remote controller installation:
Remote
controller
Remote controller
holder
Mounting screw B
ST2.9x10-C-H
Table 3-1
QUANTITYSHAPENAME
1.Hook
6. Owner's manual
7. Installation manual
2. Remote controller
3. Frame
5. Alkaline dry batteries (AM4)
2
1
1
2
2
1
1
(on some models)
1
Installation fittings
Remote controller and its
Frame
Others
4. Mounting screw(ST2.9×
10-C-H)
8 .Transfer connector( 9.52- 12.7)
(Packed with the indoor unit ,used for
multi-type models only )
(NOTE: Pipe sizes differ from appliance
to appliance.To meet different pipe size
requirements, sometimes the pipe
connections need the transfer connector
installed on the outdoor unit .)
9. Magnetic ring
(Hitch on the communication cable and
wind for two circles.)
10. Red short connected wire
(Applied to the W/L pin of outdoor unit
terminal block be short-circuited.)
1
(on some models)
1
(on some models)
6
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...