Loading ...
Loading ...
Loading ...
WARNING: The direction of feed for the workpiece is always against the
sharp edges of the cutter and into the rotation of the cutter (the cutter rotation is
counterclockwise when the router is installed in a router table). Failure to follow
this rule can result in serious personal injury.
GENERAL MAINTENANCE
,_i1_WARNING: Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial solvents and may
be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time allow brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. to come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
WARNING: When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician.
PROBLEM
The router does not
work
The table surface is
not flat
CAUSE
The router is not plugged
into the table outlet
The router table cord is
not connected to a power
source
The router table switch is
in "OFF" position
Legs are not properly
assembled
SOLUTION
Insert router power cord
plug into a table outlet
Plug the router table cord
into a power source
Insert key and pull the
switch to the ON position
Check assembly
directions and securely
tighten all fasteners
The router cannot be Sub-base is too large Use a sub-base 6-7/8 in.
attached to the table diameter or less
37599 Manual_Revised_12 1219 Page 25
Loading ...
Loading ...
Loading ...