Loading ...
Loading ...
Loading ...
See Part List (Page 12-13) for hardware illustrations referenced by number.
ATTACHING THE LEGS TO THE TABLETOP
1. Place the router table surface
upside down on a flat, level
surface.
2. Position the legs relative to the
router table as shown in Fig. 3.
3. Align the two outermost holes
on the tabletop with the holes
in the leg bracket.
4. Place small plain washers (14)
onto each of two short pan-
head screws (13). Insert the
short pan-head screws up
through the holes in the table
and through the holes in the
leg bracket. Place a small plain
washer (14), a spring washer
(15),and nut (16) on the threads
of the screw (13). Loosely
tighten the nuts (Fig. 3).
5. Place a small plain washer
(14) onto each of two long
pan-head screws (12). Insert
the long pan-head screws up
through the other two holes
in the tabletop and through
6.
Fig. 3
3racket
Fig. 4
the corresponding holes in the leg. Place a small plain washer (14), a spring
washer (15), and nut (16) on the threads of the screw (12) as shown in Fig. 4.
Securely tighten all fasteners with Philips screwdriver (not supplied).
7. Repeat with the other leg.
Page 14 37599 Manual_Revised_12 1219
Loading ...
Loading ...
Loading ...