Loading ...
Loading ...
Loading ...
To laterally adjust the in=feed
and out=feed fence
1. Unplug the router.
2. Loosen the four wing nuts.
3. Move the fence facings right
or left to the desired position
(Fig. 19). The in-feed and
out-feed fence can each be
adjusted 2 in. in order to
lengthen the fence.
4. Tighten the wing nuts.
Fig. 19
TO ADJUST THE OUT-FEED
FENCE FOR JOINTING (Fig. 20}
WARNING: Failure to unplug
your router before performing
adjustments to the router or table
could result in accidental starting
causing serious injury.
For jointing operations, the out-
feed fence can be adjusted as
much as 9/16 in. forward of the
in-feed fence to support the
workpiece after it passes across
the router bit.
Fig. 20
1. Unplug the router.
2. Loosen the two out-feed fence clamping knobs.
3. Move the out-feed fence forward of the in-feed fence to the width of
material to be removed from the workpiece. Tighten the clamping knobs.
4. Move and clamp the entire extended fence so that the out-feed fence is
aligned with the cutting edge of the bit.
Page 22 37599 Manual_Revised_12 1219
Loading ...
Loading ...
Loading ...