Loading ...
Loading ...
Loading ...
ENGLISH
9
4 Select the rotation speed indicated on
the record.
The rotation speed can be set to 33 1/3, 45 or 78 RPM.
5 Turn the START/STOP rotation knob to
START to start the turntable (platter).
o When the START/STOP rotation knob is set to START,
the turntable (platter) will start rotating and the blue
START lamp will light.
6 Slide the tone arm clasp to the right to
remove it.
Clasp
A
N
T
I
–
S
K
A
T
I
N
G
3
0
7 Raise the arm lifter lever.
Tone arm
Arm lifter lever
A
N
T
I
–
S
K
A
T
I
N
G
3
0
o You can also move the tone arm to above the record
without raising the arm lifter lever and then slowly
lower the tone arm to start playback.
8 Move the tone arm to the track where
you want to start playback.
9 Use the arm lifter lever to lower the tone
arm.
The tone arm lowers slowly until the stylus touches the
record and playback begins.
o Close the dust cover during playback. Doing so
reduces the occurrence of noise by preventing skip-
ping caused by unintended contact and blocking
external sound pressure.
V
Do not place anything on the dust cover.
ATTENTION
o During playback, do not touch the tone arm or the record.
Doing so could damage the stylus tip and cause scratches
on the record.
o Do not forcibly stop turntable (platter) rotation during
playback. Since this product is not a turntable designed
for DJs (direct drive), doing something like this could cause
malfunction.
During record playback, feedback could occur if the vol-
ume is too loud. If this happens, lower the volume of the
amplifier.
When playback finishes
1 Raise the arm lifter lever to separate the
stylus from the record, and return the
tone arm to its original position.
Tone arm
Arm lifter lever
A
N
T
I
–
S
K
A
T
I
N
G
3
0
2 Turn the START/STOP rotation knob to
STOP to stop the turntable (platter).
o The blue START lamp will become unlit and the turn-
table (platter) will stop.
Recording with a computer
The sound of a record can be digitally recorded on a computer
by using a commercially-available USB cable to connect this
unit to a USB port on the computer.
Supported operating systems
Computers running the following operating systems can be
connected by USB to this unit (as of June 2018).
Windows
Windows 7 (32-bit, 64-bit)
Windows 8 (32-bit, 64-bit)
Windows 8.1 (32-bit, 64-bit)
Windows 10 (32-bit, 64-bit)
Mac
OS X Lion (10.7)
OS X Mountain Lion (10.8)
OS X Mavericks (10.9)
OS X Yosemite (10.10)
OS X El Capitan (10.11)
macOS Sierra (10.12)
macOS High Sierra (10.13)
Use with operating systems other than these is not guaranteed.
o This unit will run with the standard Windows or Mac driver.
so there is no need to install a special driver.
Connecting with a computer
1 Turn the computer on.
Confirm that the operating system is working correctly.
2 Use the USB cable to connect the com-
puter and this unit.
o Use a commercially-available USB cable with a ferrite
core.
Continued on the next page e
Loading ...
Loading ...
Loading ...