Integra DRX2.4 User Manual

Loading ...

159

Appendix

General Specications

Amplier Section North American models Australian and Asian models

Rated Output Power

With 8 ohm loads, both channels driven, from 20-

20,000 Hz; rated 80 watts per channel minimum

RMS power, with no more than 0.08% total harmonic

distortion from 250 milliwatts to rated output. (FTC)

7 ch × 135 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD

(IEC)

Maximum Effective Output Power 170 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD

7 ch × 160 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD

(JEITA)

Dynamic Power (IEC60268-Short-term

maximum output power)

160 W (3 Ω, Front), 125 W (4 Ω, Front), 85 W (8 Ω, Front)

THD+N (Total Harmonic Distortion + Noise) 0.08% (20 Hz - 20,000 Hz, Rated output power)

Input Sensitivity and Impedance 200 mV/47 kΩ (LINE(RCA)), 3.5 mV/47 kΩ (PHONO MM)

Rated RCA Output Level and Impedance

PRE OUT (SUBWOOFER) : 1 V/470 Ω

ZONE B LINE OUT, ZONE 2 PRE/LINE OUT (*) : 200 mV/470 Ω

*1 V/470 Ω if changed to PRE OUT (FRONT)

Phono Maximum Input Signal Voltage 70 mV (MM 1 kHz 0.5%)

Frequency Response 10 Hz - 100 kHz/+1 dB, –3 dB (Direct)

Tone Control Characteristics ±10 dB, 20 Hz (Bass), ±10 dB, 20 kHz (Treble)

Signal to Noise Ratio 106 dB (IHF-A, LINE IN, SP OUT), 80 dB (IHF-A, PHONO IN, SP OUT)

Speaker Impedance 4 Ω - 16 Ω

Headphone Rated Output 80 mW + 80 mW (32 Ω, 1 kHz, 10% THD)

Supported impedance of Headphones 8 Ω - 600 Ω

Headphones Frequency Response 10 Hz - 100 kHz

Loading ...

Integra DRX2.4 7.2 Channel Black Network A/V Receiver