Loading ...
Loading ...
Loading ...
2r Install Clutch Rod in Clutch Lever (Fig° I3} Secure with
Retainer Spring
3. Move Lift Lever /Fig 15) forward to }ower Suspension
Arms. Slide Trunnions through Lift Bracket holes and se-
cure with Retainer Springs (Fig t3).
4 Roll Belt over Mower Drive Pulley Make sule Belt is inside
Belt Guides (Fig. 1;4) See Belt Drive Schematic Decal on
Mower Housing
5. Use Lift Lever (Fig. 15) to raise mower
NOTE: SEE MOWER ADJUSTMENT, BELOW
6, Turn Depth Adjustment Knob clockwise (/_) to the mid-
dle of it's travel
At J]U $TMI I T
FOR ANY ADJUSTMENTS, INSPECTION
OR MAINTENANCE:
PUSH TRACTOR CLUTCH-BRAKE PED-
AL COMPLETELY INTO BRAKE POSI-
TION. MOVE GEAR SHIFT LEVER TO
"N" NEUTRAL POSITION_ PLACE PARK-
ING BRAKE IN "ENGAGED" POSITION.
PLACE ATTACHMENT CLUTCH LEVER
IN "DISENGAGED" POSITION. SHUT
OFF THE ENGINE. MAKE ABSOLUTELY
SURE THE BLADES AND ALL MOVING
PARTS HAVE COMPLETELY STOPPED,
REMOVE THE IGNITION KEY, DISCON-
NECT THE SPARK PLUG WIRE FROM
THE SPARK PLUG AND KEEP WIRE
AWAY FROM THE PLUG TO PREVENT
INJURY FROM ACCIDENTAL START-
ING.,
NOTE: BEFORE CHECKING THE SIDE TO SIDE AND
FRONT TO REAR ADJUSTMENTS, PAGES g AND 10, BE
SURE PRESSURE IN FRONT TIRES IS 14 PSI AND PRES-
SURE IN REAR TIRES IS 12 PSI. IF TIRES ARE OVER OR
UNDER INFLATED YOUWILL NOT PROPERLY ADJUST
YOUR MOWER
CLUTCH
\ROD ,., .. RETA,NER SPRING \
\ /f /OLUTCRLEVER
ARM t\ \ _ / _/" RETAINER SPRING
J _ -\--\--./-- "-S /
RETAINER BRACKET HINGE
SPRING PIN
FIGURE 13
l
FIGURE 14
LEVEL FRO SUDIE $1 31E
1_ Park tractor on level surface Depress Lift Lever Plunger
and use Lift Lever to raise mower to maximum cutting
height=
2, Measure height of Flange to revel surface at front of mower
Distance "A='should be the same (Fig 15)
LIFT LEVER
PLUNGE_L_FvTER
FLANGE
A
SIDE-TO-SIDE
ADJUSTMENT
__AFLANGE
- 9- FIGURE 15
Loading ...
Loading ...
Loading ...