Loading ...
Loading ...
Loading ...
POSITIVE
(RED CABLE)
TERMINAL
FIGURE 10
NEGATIVE
(BLACK CABLE)
TERMINAL
STARTBNG YOUR TRACTOR WSTH
A LGW BATTERY
If your Battery is too low to start the engine, it should be
recharged If "Jumper Cables" a rti• reused for emergency sta ng
follow this procedure: NOTE: YOUR TRACTOR IS EQUIP-
PED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM,
THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGA-
TIVE GROUNDED SYSTEM.
LEAD-ACID8ATTER,ESGENERATEE×--!
PLOSIVE GASES. KEEP SPARKS. FLAME. |
AND SMOKING MATERIALS AWAY |
FROMBATTERIES.ALWAYSWEAREYE!
PROTECTION AROUND BATTERIES° /
J
1. Connect each end of the RED cable to the POSITIVE (+)
terminals of each battery (taking care not to short against
chassis) (Fig. 10).
2. Connect one end of the BLACK cable to the NEGATIVE
(-) terminal of fully charged battery_
3. Connect the other end of the cable to ENGINE BLOCK
ol good CHASS)S GROUND on tractor (away from Gas
Tank or Battery).
4. Disconnect cables in reverse order:
a_ Engine B)ock or chassisof tractor.
b. Negative terminal of fully charged battery.
c. Positive terminals°
MOWER
PARALLEL
LINK
FIGURE 11
LIFT
LEVER
RETAINER
SPRING
CLUTCH
_OWER AND I_$_aVE {_IELT
gNSTALLAT_@N
Your tractor has been shipped with the Mower Parallel Link
banded to the frame_ Remove bands and lower Mower Parallel
Link (Fig. 11).
_OWER INSTALLATB O{_
Your 44" Mower installs without the use of tools, Raise Lif_
Lever (Fig_ 12) to its highest position, Turn Depth Adjustment
Knob to lowest position (Fig. 19).
1. Install Rear Hinge Pin through Mower Lift Brackets and
Parallel Link (Fig 13L Secure with Retainer' Spring.
FIGURE 12 - 8-
Loading ...
Loading ...
Loading ...