Loading ...
Loading ...
Loading ...
5,InstallBatteryusing:twoInt=/E_xt,Lockwashers,two Wing
Nuts (shown full size below) and
INT./EXT, WING WING NUT
LOCKWASHER NUT
©
INT./EXT.
ACCESS
DOOR
_INAL
GUARD
TERMINAL
ACCESS DGOR
two Battery Bolts and one Terminal Guard found in Bag of
Parts,
a. LJsingthe square hole on one side of the Battery Support
(Fig. 4) insert one Battery Bolt, head of Bolt down,
Fasten the Battery Bolt to the Terminal Guard using
Int,/Ext Lockwasher and Wing Nut as shown in Fig, 4.
b Assemble the remaining Battery Bolt to other side of
Battery Support and fasten Terminal Guard to it with re-
maining }nt/Ext Lockwasher and Wing Nut, Tighten
Wing Nuts securely by hand (Fig 4).
NOTE: USE TERMINAL ACCESS DOORS (FIG. 4) FOR:
! Inspection for secure connedtions (tighten hardware),
2 Inspection for corrosion
3 Testing battery
4 Jumping (if required).
5 Charging (if required)
BOLT
SUPPORT
FIGURE 4
_ STEERING WHEEL CAP
_HEX NUT
_ER
WHEN NOT IN USE, KEEP TERMINAL
ACCESS DOORS CLOSED.
DO NOT START ENGINE UNTIL MOWER
PARALLEl LiNK HAS BEEN RELEAS-
ED, SEE MOWER AND DRIVE BELT IN-
STALLATION, PAGE B_
6 Replace Air Intake Duct (Fig, 2},
7. Close Hood,
8_ Install Steering Wheel.
NOTE: POSITION FRONT WHEELS FORWARD°
a° Remove Hex Nut and Large Washer from Steering
Column (Fig, 5),
b, Position Steering Wheel over Steering Wheel Insert.
c, Secure Steering Wheel to Steering Column using Large
Washer and Hex Nut (Fig. 5),
d, Snap Steering Wheel Cap in place on Steering Wheel.
Steering Wheel Cap found in Bag of Parts,
9. To adjust seat position, swivel seat forward. Use 3/4"
wrench to loosen Seat Bolt and slide seat to desired posi-
tion. Make sure seat sets straight on Seat Pan and tighten
Seat Bolt securely (Fig, 6).
.5-
/
STEERING WHEEL
SEAT PAN
SEAT BOLT
\
FUEL
TANK
CAP
Loading ...
Loading ...
Loading ...