Loading ...
Loading ...
Loading ...
//
BRAKESPRING
5_ Use pliers to remove Brake Spring (Fig, 29),
6. Remove Cotter Pin from Brake Rod (Fig, 39)
7. Pull Belt out from under Brake Rod and off mower
9. To install belt, reverse above procedure Make sure belt
is engaged in all pulleys,
9,. Replace Brake Spring, Brake Rod and Retainer Spring,
Tighten two Nuts on Belt Guard and Nut on L.H_ Idler
Pulley (Fig. 27)
FIGURE 29
PIN
E ROD
\
TO REMOVE MOWER
1 Remove mower Belt per instructions under "To Remove
Mower Bert", through step 3,
2. Turn Depth Adjustment Knob to lowest position= Use Lift
Lever to lower mower to its ],west position
3. Remove Retainer Spring from Clutch Rod; pull Clutch Rod
out of Clutch Lever'
4
50
6.
7,
Pull Retainer Springs out of Rear Suspension Trunnions_
Remove Rear Suspension Trunnions from Lift Brackets
(Fig, 31).
Pull Retainer Spring out of Rear Hinge Pin= Remove Rear
Hinge Pin (Fig, 31L
Pull Retainer Spring out of Front Hinge Pin, Remove Front
Hinge Pin (Fig, 31).
Use Lift Lever to raise Suspension Arms, Slide mower out
from under tractor=
FIGURE 30
STOR .GE
When mower is to be stored for a period of time, clean it
thoroughly, remove all dirt, grease, leaves, etc. Give blades
and underside of housing a good coat of grease or rust pre-
ventative, S(ore in a clean dry area
FIGURE 31
-14-
Loading ...
Loading ...
Loading ...