Loading ...
Loading ...
Loading ...
SIDE-TO=SIDE
NUT"B"
3_ • ii ii ..... . ,
If distance A needs to be changed, snap out Access Hole
II
Cover on L.H. side above Footrest= Use 9/16 wrench on
Nuts "B" and "C" at Side-To-Side Adjustment Trunnion
(Fig. 16L
4. To raise left side of mower, loosen Nut "B" and tighten
Nut "C'.
5_
To lower left side of mower, loosen Nut "C" and tighten
Nut _=B"_
NOTE: ONE ROTATION OF ADJUSTMENT NUTS IS
EQUIVALENT TO APPROXIMATELY 3/16" HEIGHT
CHANGE.
6. BesureallNutsaresecurelytightened.
NOTE:SEE MOWER ADJUSTMENT, FRONT-TO-REAR,
BELOW,
FIGURE 16
FIGURE 17
NUT "E'_
NUT "F"
/
FIGURE 18
f
FLANGE
ADJUST MOWER FROM FRO JT
TO REAR
1.
2
To obtain the best cutting results, your Mower Housing
should be adjusted so the Front and Rear Flange distance
"D" (Fig, 17) is 5/16" lower in front when the mower is
positioned in the highest cutting position.
NOTE: MEASURE DISTANCE lID" FROM SURFACE TO
RIGHT REAR FLANGE AND COMPARE TO DISTANCE
"D'ON RIGHT FRONT FLANGE,
To raise rear of mower, loosen Nut "E _ on both Rear Sus-
pension Arms. Sclew both Nuts "F" up EQUAL NUMBER
OF TURNS (Fig 18)
3_ When distance "D" is 5/16" lower at front than rear, tight-
II II
en Not E .
4 To lower rear of mower, loosen Nut "F" on both Rear'
Suspension Arms an EQUAL NUMBER OF TURNS (Fig
16)
5, When distance hD" is 5/16" lower at front than rear, re-
tighten Nuts "E',
NOTE: WHEN ADJUSTING REAR SUSPENSION TRUN-
NIONS, ALWAYS ADJUST BOTH EQUALLY SO MOWER
WILL STAY LEVEL
DEPTH ADJUSTMENT
Adjustment for mower height is made with the Depth Adjusta:
ment Knob• Raise Mower cutting height by turning Depth
Adjustment Knob clockwise ( _ }, Lower Mower cutting
height by turning Depth Adjustment Knob counterclockwise
(f_) (Fig, 19),
DEPTH ADJUSTMENT
KNOB
FIGURE 19 - 10 -
Loading ...
Loading ...
Loading ...