WSE7000SF USER MANUAL

Loading ...

32 care & maintenance

FREEZER LIGHT (WHERE FITTED)

1. Switch off the power at the power point and remove

therefrigerator’spowercordfromthepowerpoint.

2. Carefully unclip the light cover by pulling the light cover

tab at the rear, towards you. Unclip the light cover by

pressing side tabs on both sides and pulling the light

cover away from you (Ice & Water models).

Models WSE7000 & WSE6100

Models WSE6970 & WSE6070

3. Unscrew the light bulb and replace it with a new bulb

of the same type and wattage. If, when you remove the

lightbulbthesmallrubber‘O’ringcomesoutwiththe

bulb,fitthe‘O’ringoverthenewbulbandscrewbulb

into the socket (see diagram at bottom of page).

WARNING

Never insert your finger into the light bulb socket to

checkforthepresenceofthe‘O’ring.

4. Replacethelightcoverbyhookingthelightcoverlugs

into the front of the housing and pressing the rear of the

cover up until it clips in.

5. Wait 5 minutes to ensure pressures in the refrigeration

system are equalised before turning the refrigerator on

at the power point.

WARNING

Ensure the ‘O’ ring is in place before replacing the bulb.

Lightbulb ‘O’ring Lightsocket

CLEANING THE EXTERIOR

WARNING

BEFORECLEANING:Turntherefrigeratoroffatthe

power point and unplug the cord to prevent any chance

of electrocution.

Cabinet & painted doors – An occasional wipe over with

a clean, damp cloth will help remove finger marks. You

should only clean the doors with lukewarm, soapy water

andasoftcloth.Rinsewithcleanwaterandthenwipe

the surface with a soft, clean cloth to remove any

soapy residue.

Note: Only wash plastic parts or decorative trim with warm

(not hot) water using an unscented detergent.

Stainless Steel doors –Your stainless steel appliance is

manufactured from a mark resistant stainless steel. This stainless

steel has a special advanced protective coating that helps

ease the removal of marks such as finger prints or water spots.

To keep your stainless steel refrigerator looking its best, you

should clean it regularly. You should only clean the stainless

steeldoorswithlukewarmsoapywaterandasoftcloth.Rinse

with clean water and then wipe the surface with clean water

and a soft, clean cloth to remove any soap residue.

CAUTION

Do not use abrasive pads or other cleaners as they are

likely to scratch the surface. Damage to this product after

installation is not covered by your warranty.

Note: It is important to wipe in the direction of the grain of

the stainless steel to avoid any undue marking of the surface.

Drip tray

Water may accumulate in the sump located under the drip

tray. If this occurs the sump can be sponged out to prevent

water overflowing down the front of the door.

For cleaning, remove the tray as described below:

1. Press down at the back of the drip tray with the tips

of your fingers.

2. Pull the tray forward.

3. To refit, slide the drip tray back into position and

push into place (see Diagram below).

1. Push down

2. Slide out

CHANGING THE LIGHT BULB CLEANING YOUR REFRIGERATOR

Loading ...

USER MANUAL - Page 32