Loading ...
Loading ...
Loading ...
12 installation
BEFORE BEGINNING INSTALLATION, PLEASE READ:ICE & WATER INSTALLATION
THE EXTERNAL WATER FILTER KIT
An external water filter and connection kit has been
supplied for use with your Ice & Water refrigerator. The external
filter design allows more space within the refrigerator and
provides double the life of previous filters reducing the cost
of replacement.
The filter is designed to significantly reduce chlorine,
taste, odour, heavy metals, turbidity (cloudiness) and scale
build up. The included plastic water tube allows quick
connection to the filter and is designed for high durability
and kink resistance.
This filter is designed only to be used with a potable water
supply. It should not be used on water that is micro
biologically unsafe or with water of unknown quality. The
filter should be replaced every 12 months. The service life of
the filter may be reduced in water supplies that contain an
excessofparticlesorotherimpurities.Reducedflowrateisan
indication that a new filter is required. Failure to replace the
filter when required can affect the function of the ice maker.
Service calls caused by a failure to replace the filter are not
covered by warranty.
CONTENTS OF KIT –INSTALL KIT WITH PRESSURE
REDUCING VALVE.
DATE FITTED___/___/___
1 x water filter with push fit connections
DATE FITTED___/___/___
2 x mounting brackets and screws
4 + 1 metres of water tubing
1 x ½" tap fitting
2 x circlips
The water connection to your ice and water product can
be self-installed. It is recommended that you seek advice
from a licensed plumber (if necessary) before commencing
the installation.
CAUTION
Your warranty may be voided by an incorrect installation
Water Supply and Plumbing
Adrinkablewatersupplytosuita½’tapfittingisrequired
adjacent to the refrigerator. It is recommended that a
licensed plumber install a new water supply outlet nearer
to the appliance should the tubing supplied not be
long enough. It is not recommended that the tubing be
extended as this could adversely affect the flow of water
to the ice maker or water dispenser.
The water dispenser and automatic ice maker require a
drinkable water supply with a pressure range of between
206kPa and 689kPa (30PSI and 100PSI). If the water
supply pressure is below 206kPa (30PSI) then a separate
pump will need to be installed.
ItisrecommendedthataNoiseReductionValvealso
be fitted in the water supply line. This will reduce water
hammer and its effects from quick action house hold taps
and fast acting valves on appliances. The refrigerator
water valve is pre-fitted with a push-fit connector for
inserting the water tube. Where the tap connection is other
than1/2’,adapterscanbepurchasedfromplumbing
supply stores or good hardware stores.
Water Filter
Locatethewaterfilterwithin1metreofthewatersupply
tap, in a vertical orientation where possible. The filter
will need to be replaced every 12 months to prevent
excess filtered micro-organism build-up, and thus ensure
continuous purified water and ice supply for you and
yourfamily.Replacementwaterfiltersareavailablefrom
Electrolux Home Products Spare Parts Centres and can be
posted to you for your convenience (refer to back page for
contact details).
WARNING
If the appliance is not connected to a water supply ensure
that the ice maker is switched off (refer to STEP 1 overleaf).
Ifyoudon’tdothisaloudbuzzingnoisewillbeheard
intermittently. The new hose-sets supplied with the appliance
must be used and old hose-sets should not be reused. Do
not use with water that is microbiologically unsafe or with
water of unknown quality without adequate disinfection.
Never connect the appliance to a hot water supply.
Never install the water filter in an area of the wall where
there may be electrical wires and/or water supply pipes.
Never install the water filter in an area of direct sunlight.
DATE FITTED___/___/___
Loading ...
Loading ...
Loading ...