Loading ...
Loading ...
Loading ...
installation 15
ICE & WATER INSTALLATION
Step 15.
Using a large container run the water dispenser to clear air
from lines. This may take a few minutes. Purge and dispense
a minimum of 2 litres of water or until the water runs clear.
Initial water may be black in colour. This is residual carbon
dust from the filter and is non-toxic. If the water is slow to
shut off or the dispenser is dripping, air may still be in the
lines. Either purge more water through the system to remove
this air or allow some time for the air to be removed over
subsequent dispensing.
Step 16.
Switch ON Ice Maker, touch and hold ‘cubed/crushed
ice’buttonfor5seconds.
freezer
temp
fridge
temp.
eco/
holiday
quick
freeze
display
lock
drinks
chill
Step 17.
After 24 hours remove ice bin and dispose of first few
batches of ice to ensure that impurities have been flushed
from the system.
Tips and Useful Information
Ensure that taps are turned off when replacing
andfittingfilters.Remembertoturnthetapsback
on when filter fitting is complete.
Alwaysfitfilteraspermanufacturer’sinstructions,
paying special attention to water flow direction.
If you need to replace water tube, only use
approved water quality piping that meets the
pressure requirements.
Do not allow the water tubing to become kinked
or trapped under the refrigerator when moving the
refrigerator back into position.
Make sure your refrigerator is level to avoid uneven
or oversize cubes. Uneven ice cubes may lead to
the dispenser chute becoming blocked.
After installation, run the water dispenser for a few
minutes to ensure that all air bubbles have been
purged from the tubing. Dripping may occur if air
bubbles remain in the tube.
Replacelteratsuggestedintervalstoavoid
water/ice reduction and irregularities in taste.
Removeandcleanicebinonceamonth,
discarding unused ice cubes. This will ensure fresh,
clean ice and smooth operation of your ice maker.
Clean and empty the dispenser drip tray regularly
to avoid overflow.
As the water/ice cut off is not instant, leave glass
under dispenser briefly until water or ice has
stopped flowing to avoid spills.
Always place ice in glass before filling with water
to avoid splashing.
When dispensing ice hold the container close to
the chute to avoid spray or spills.
If you are using your refrigerator for the first time, or if you
have not used the dispenser for some time:
• Discardthefirstsevenoreightcupsofwater
• Discardanyicethattheicemakerproducesinthe
first 24 hours (contaminants could have settled in the
water pipes)
Loading ...
Loading ...
Loading ...