Loading ...
Loading ...
Loading ...
Assembly / Owner’s Manual
54
2. Unplug the treadmill fully from the wall outlet, and remove the power cord from the machine.
To reduce the risk of electrical shock, always unplug the power cord and wait 5 minutes before cleaning,
maintaining or repairing this machine. Place the power cord in a secure location.
Note: Make sure the treadmill is located on a surface that is easy to clean.
3. Apply a few drops of the lubricant on the deck below the belt. Carefully lift the belt and apply a few drops of the lubricant the entire width of the
belt. A very thin layer of silicone lubricant on the entire deck below the belt is desired.
NOTICE: Always use a 100% silicone lubricant. Do not use a degreaser like WD-40
®
as this could seriously impact performance. We can
recommend that you use the following:
• 8300 Silicone Spray, available at most Hardware and Auto Parts stores.
• Lube-N-Walk
®
Treadmill Lubrication Kit, available from your local specialty tness dealer or Nautilus, Inc.
Store silicone lubricant in a safe place. Keep out of reach of children. Silicone lubricant is not intended for human consumption.
4. Manually rotate the belt 1/2 of the length of the belt and apply lubricant again.
5. Connect the power cord back into the machine and then into the wall outlet.
6. Turn on the power to the machine with the power switch.
7. Stay to one side of your machine and start the belt at the slowest speed. Let the belt operate for approximately 15 seconds.
Be sure not to touch a moving walking belt or step on the power cord. Keep bystanders and children away from the product you are
servicing at all times.
8. Switch off your machine.
9. Take care to clean up any excess lubricant from the deck.
To decrease the possibility of slipping, be sure the deck area is free from grease or oil. Clean off any excess oil rom the machine
surfaces.
Heart Rate Chest Strap Battery Replacement
The heart rate (HR) chest strap uses a CR2032 battery.
!
Do not perform this procedure outdoors or in moist or wet locations.
1. Using a coin, loosen the slotted cover on the battery bay. Remove the cover
and battery.
2. When replacing the battery, insert it in the battery bay with the + symbol
facing up.
3. Reinstall the cover on the strap.
4. Discard the old battery. Dispose of in accordance with local regulations and/or at approved recycling centers.
5. Inspect your chest strap to ensure function.
Do not use until the equipment has been fully assembled and inspected for correct performance in accordance with the Owner’s
Manual.
CR2032
+
Loading ...
Loading ...
Loading ...