Loading ...
Loading ...
Loading ...
Assembly / Owner’s Manual
52
Read all maintenance instructions fully before you start any repair work. In some conditions, an assistant is required to do the necessary tasks.
Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that regular maintenance is
done. Worn or damaged components must be repaired or replaced immediately. Only manufacturer supplied components can be
used to maintain and repair the equipment.
If at any time the Warning labels become loose, unreadable or dislodged, replace the labels. If purchased in US/Canada, contact
Customer Service for replacement labels. If purchased outside US/Canada, contact your local distributor for them.
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power
cord from the wall outlet and the machine and wait 5 minutes before cleaning, maintaining or repairing the
machine. Place the power cord in a secure location.
Daily: Before each use, examine the exercise machine for loose, broken, damaged, or worn parts. Do not use if found in this
condition. Repair or replace all parts at the rst sign of wear or damage, except for the Walking Deck. The Walking Deck
is designed for wear on both sides of it. If only one side of the Walking Deck is worn, a replacement Deck is not required.
It is recommended that a qualied service technician is used to ip the Walking Deck. After each workout, use a damp
cloth to wipe your machine and Console free of moisture.
With the Walking Deck lowered, if an edge of the Walking Belt can be seen, adjust it until the edge is not
viewable.
Note: Avoid excessive moisture on the Console.
Weekly: Check for smooth roller operation. Wipe the machine to remove dust, dirt, or grime.
Do not remove the Motor Control Board (MCB) Cover. Dangerous voltages and moving parts are present.
The components are serviceable only by approved service personnel or by following service procedures
supplied by Nautilus, Inc.
Note: Do not use petroleum based products.
Monthly
or after 20 hours:
Make sure all bolts and screws are tight. Tighten as necessary.
Quarterly: Or after 25 hours—Lubricate the walking belt with a silicone-based lubricant.
Silicone lubricant is not intended for human consumption. Keep out of reach of children. Store in a safe
place.
.
Cleaning
To reduce the risk of electrical shock, always unplug the power cord and wait 5 minutes before cleaning,
maintaining or repairing this machine.
Wipe the treadmill down after each use to keep the treadmill clean and dry. It may be necessary to use a mild detergent at times to remove all dirt
and salt from the belt, painted parts and the display.
NOTICE: To prevent damage to the nish of the machine or Console, do not clean with a petroleum based solvent. Do not apply too much
moisture to the Console.
Adjusting the Belt Tension
If the walking belt starts to slip during use, it is necessary to adjust the tension. Your treadmill has tension bolts at the rear of the treadmill.
1. Make sure that the walking belt is stopped and the power switch is turned Off.
Maintenance
Loading ...
Loading ...
Loading ...