Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 35
To adjust the seal compression, proceed as follows:
1. Open the door and lift the upper half-door up and
away from the lower half. Lay the upper half-door on
a clean, dry surface.
2. Using an 8 mm open-end wrench (not provided),
loosen the nut located inside the bottom of the upper
half-door post, closest to where the “paper test”
detected a gap.
Nut Location Inside Bottom Of Post
3. Using a 3 mm Allen wrench (not provided), rotate the
screw on the side of the post counterclockwise (while
holding the wrench on the loosened bolt) to increase
the seal compression. If needed, rotate clockwise to
reduce seal compression.
Rotate Screw For Seal Compression
4. Tighten the nut inside the bottom of the post using
the wrench and make sure the screw head is flush to
the post. Reinstall the upper half-door.
Screw Head Flush To Post
5. Close the door and repeat the “paper test”. Repeat
the adjustment procedure if needed.
6. If needed, add the provided shim to a lower half-door
pocket to seal the upper half-door to the roof:
a. Lift upper half-door up and away from lower half.
b. Clean the bottom of the door pocket.
Remove Upper Half-Door & Clean Bottom Of Door Pocket
c. Slide the shim onto a pencil or similar tool.
d. Remove the paper backing from the adhesive side
of the shim and place the shim with pencil into the
pocket.
e. Press the shim firmly to the bottom of the pocket,
and remove the pencil once the shim is firmly in
place.
1 — 3 mm Allen Wrench
2 — 8 mm Open-End Wrench
2
23_JL_OM_EN_USC_t.book Page 35
Loading ...
Loading ...
Loading ...