Loading ...
Loading ...
Loading ...
98 GETTING TO KNOW YOUR VEHICLE
LOWERING THE WINDSHIELD
1. Before completing the following steps:
If your vehicle is equipped with a Soft Top, the top
MUST be lowered, and the door rails must be
removed prior to lowering the windshield.
If your vehicle is equipped with a Hard Top, the
Freedom Panels
MUST be removed prior to
lowering the windshield.
Refer to the following instructions for more infor-
mation:
• Soft Top Lowering
Ú page 75
• Door Frame
Ú page 95
• Freedom Top Panels
Ú page 83
2. Manually remove the protective caps over the
windshield wiper hex bolts.
Step Two
3. Using the provided 15 mm socket, remove the two
hex bolts and remove the wiper arms.
4. Move to the inside of the vehicle and lower both sun
visors.
5. Using the provided #40 Torx head driver, remove the
four Torx screws located along the interior of the
windshield.
Step Five
NOTE:
Store all of the mounting bolts in their original threaded
holes and tighten for safekeeping.
Be sure that you carefully follow the instructions for
raising the windshield. Make sure that the folding
windshield, windshield wipers, side bars, and all
associated hardware and fasteners are correctly and
tightly assembled before driving your vehicle. Failure
to follow these instructions may prevent your vehicle
from providing you and your passengers’ protection
in some accidents.
If you remove the doors, store them outside the
vehicle. In the event of an accident, a loose door may
cause personal injury.
WARNING!
CAUTION!
Failure to follow this step will cause damage to the
vehicle’s header seal.
1 — Hex Bolt Cover Installed
2 — Hex Bolt Cover Removed
1 — Outside Torx Screws
2 — Inside Torx Screws
23_JL_OM_EN_USC_t.book Page 98
Loading ...
Loading ...
Loading ...