Loading ...
Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS
Foryourownsafety,neverconnectplugtopower
sourceoutletuntilall assemblyand adjustmentsteps
arecompleted, andyou havereadand understood
the safetyandoperatinginstructions.
TOOLS NEEDED
_ w_encb
III t lilt IIIt_
Frw_ing
8"S 10"AdJustab__
Comb_e_m_tre
The DdlTPressisvery heavyand MUST be liftedwiththe
helpof 2 PEOPLE OR MORE, to safetyassembly it.
COLUMN SUPPORT TO BASE (FIG. A)
1. Position the base (1) on the floor.
2. Place the column (2) on the base, aligning the
holes in the column support with the holes in the
base.
3. Locate the four long hex bolts (3) from the loose
parts bag.
4. Place a bolt in each hole through the column
support and the base. Tighten with an adjustable
wrench.
i
INSTALLING THE TABLE (FIG. B and C)
1. Locate the table crank (1) and support lock (2) from
the loose parts bag.
2. Insert the support lock handle intothe hole (3) at
the rear of the table support assembly. Tighten by
hand.
3. InstaJIthe table crank handle (3) onto the small
shaft (4), aligning the set screw (5) with the flat
surface of the shaft (4), aligning the set screw (5)
with the fiat surface of the shaft. Tighten the set
screw with a hex wrench.
10
Rg. B
4. (FIG. C) Loosen the support lock (2). Raise the
table arm assembly by turning the crank handle (1)
clockwise. Tighten the support lock.
5. Place the table (6) in the table arm assembly.
Tighten the table lock handle (7).
Rg. C
INSTALLING EXTENSION WING
1. Place the handle (OWVG) onto the upper tube
(OWVH).
2. Place the flat washers (OT6T) onto the hex head
bolts (OJUB). Insert the bolt (OJUB) intothe upper
tube (OWVH), and tighten.
3. Insertthe hes head bolts (OJUB) onto the upper
tube (OJUB) and tighten.
4. Place the upper tube assembly under the table.
5. Place the set plate (OWVJ) ontothe clamp bolt
(OWVK). Insert the set plate assembly intothe
table and tighten.
NOTE: If length adjustment is necessary, loosen
the clamp bolt (OWVK) to the desired length and
tighten the clamp bolt.
OWVE
Loading ...
Loading ...
Loading ...