Loading ...
Loading ...
Loading ...
• The burners should be cleaned annually, or
whenever heavy build-up is found, to ensure that
there are no signs of blockage (debris, insects) in
either the burner portholes or the venturi tubes
of the burners tted over the valve outlets. A
clogged tube can lead to a re beneath the grill.
Vapor Bar
• Clean the vapor bar with soap and warm water
using a low abrasive cleaning cloth or sponge.
CAUTION: SPIDER ALERT! Spiders or small insects
can create “ashback” problems. The spiders
spin webs or build nests in the grill burner tubes,
obstructing the ow of gas to the burner. The
backed-up gas can ignite in the tube behind the
control panel. This is known as ashback and can
damage your grill or cause personal injury. To
prevent ashback and ensure good performance,
remove and clean the burners before use whenever
the grill has been idle for an extended period.
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace
parts of burner assembly or if you have trouble
igniting grill.
1. Turn gas o at control knobs and LP cylinder.
2. Remove cooking grills, searing grill and vaporiser
bars.
3. Remove the screws from the ignition plates
connecting the burners. See Fig. A below.
4. Remove the screws from the connection between
the burner and the ignition bracket on the
underside of the rebox. See Fig. B.
5. Remove the screws on the back board of the
rebox. See Fig. C.
6. Fully remove the burner assembly from the
rebox.
We suggest the following ways to clean the burner
tubes. Use the one easiest for you.
(A) Using a narrow bottle brush or alloy wheel
brush with a exible handle (do not use a brass
wire brush), run the brush through each burner
tube several times.
(B) Wear eye protection: Use an air hose to force air
into the burner tube and out the burner ports.
Check each port to make sure air comes out
each hole.
27
Fig. A
Fig. B
Fig. C
Fig. D
Loading ...
Loading ...
Loading ...