Loading ...
Loading ...
Loading ...
90 GETTING TO KNOW YOUR VEHICLE
To install the crossbars, refer to the following procedure:
1. Remove the crossbars from the foam blocks.
2. Swivel the outboard stanchion on the crossbar and
rotate it 180 degrees around the bolt to the open
position. Open the outboard stanchion on the
opposite end of the crossbar as well.
Step 2
Open Outboard Stanchion (Underside Shown)
3. Using the provided Torx wrench, loosen the Torx bolts
on both ends of the crossbar.
Step 3
4. Using the provided wrench and fasteners, bolt the
fasteners to the side rail.
Torque Wrench Indicator
NOTE:
An indicator on the wrench will show when the fastener is
tightened to the indicated torque specification. The
slanted line will line up with the arrow when torquing.
Step 4
5. Tighten down the Torx head bolts on the inboard
stanchion.
Step 5
23_WS_OM_EN_USC_t.book Page 90
Loading ...
Loading ...
Loading ...