Loading ...
Loading ...
Loading ...
21
COMPUTER INSTRUCTIONS
Target WattNo Arrow Indicator here
The program will
adjust the workload
automatically.
If the Arrow
Indicator appears as follows, it means your pedaling speed is too low. Please pedal
faster.
P
edaling speed is too low, almost out of the range that the program can adjust the workload for
you. Please pedal
faster.
P
edaling speed is too low and out of the range that the program can adjust the workload for you,
and
the computer will remind you with an audible alarm
. Please pedal
faster.
If the Arrow
Indicator appears as follows, it means your pedaling speed is too fast. Please pedal
slower.
P
edaling speed is too fast, almost out of the range that the program can adjust the workload for
you. Please pedal
slower.
P
edaling speed is too fast and out of the range that the program can adjust the workload for you,
and
the computer will remind you with an audible alarm
. Please pedal
slower.
( ) USER SETTING
USER SETTING PROGRAM: Program “ ” is an automatic program that allows
the user to manually preset each of the 8 intervals. Select this program, use
the UP/DOWN dial and MODE button to edit the program profi le. The program
profi le will be stored in the memory after setup. You can modify the profi le
anytime once you select this program.
When running the program, you still can use the UP/DOWN dial to increase
or decrease the load level of each interval and these changes will be stored in
memory.
8
6
4
2
4
2
8
6
16
14
12
10
USER SETTING PROGRAM OPERATION
1. Start pedaling or press any button to wake up the computer. Press the RESET button to skip to program
selecting mode to select the user setting program. Or, press the RESET button and hold it down for two
seconds to skip to initial mode. You can select the “user”, then skip to program selecting mode to select
the user setting program.
2. Use the UP/DOWN dial and MODE button to select the program “
” ( User Setting Program).
3. After pressing the MODE button, interval 1 will begin fl ashing. Use the UP/DOWN dial to set the load
for interval 1. Press the MODE button to confi rm and proceed to the next interval. Use the UP/DOWN
dial and MODE button to set the load for each interval. When all the intervals are set, press the MODE
button and hold it down for two seconds to skip to setting mode for presetting the function value of TIME,
from 1:00 to 99:00 min. Or, press the START/STOP button to run the program directly without presetting
the TIME function value.
4. After using the UP/DOWN dial to input the value of TIME, press the START/STOP button directly to run
the program to workout.
When running the target watt control program, the program
will monitor your pedaling speed and adjust the workload
automatically to keep your workload as close as possible to
the preset target WATT. For example, if the preset target WATT
is 120 and you pedal with proper speed, the display will be as
shown in the illustration. There should be no Arrow
Indicator
appearing on the display.
Loading ...
Loading ...
Loading ...