Loading ...
Loading ...
Loading ...
Installingthe PT0/Deck Belt
Make certain that the PTO!Deck belt is routed
around the spindle pulleys (found beneath the belt
guards) and both idler pulleys as illustrated in
Figure 5 before proceeding.
Relieve tension on the deck idler by inserting a 3/8"
drive ratchet wrench (set to "loosen") in the hole
found in the idler bracket and pivoting the wrench
handle counterclockwise. See Figure 5.
IMPORTANT: Be certain that the FLAT side of the PTO/
Deck belt is the side coming in contact with the deck
idler pulleys.
With the tension relieved, carefully route the belt
around the electric PTO clutch.
NOTE: If necessary, refer to the decal found on the
deck's surface or on page 19 of this manual for a
detailed belt-routing diagram.
3/8" Square Hole
Spring
Figure 5
Beck RollerHeightAdjustment
To adjust the height of the rollersfound on the rear of
the mowing deck upward or downward, proceed as
follows:
Place the deck lift lever inthe bottom notch (lowest
position).
Remove the clevis pins and hairpin clips from the
deck roller brackets on the left and right sides of the
cutting deck. See Figure 6.
Position the deck roller brackets up or down
through the slots on the rear of the deck until
desired position is reached, then re-attach with the
clevis pins and hairpin clips just removed. See
Figure 6.
IMPORTANT:Be certain that the left roller bracket and
the right roller bracket are set in the same position.
IMPORTANT:After mounting the cutting deck, perform
any adjustments on the deck, if necessary, prior to
operating the tractor. Refer to page 16 for instructions.
Hairpin Clip
Deck Roller Bracket
Clevis pin
Figure 6
Loading ...
Loading ...
Loading ...