Subaru 2022 WRX GT

User Manual - Page 296

For 2022 WRX GT.

PDF File Manual, 520 pages, Download pdf file

Loading ...
Loading ...
Loading ...
(292,1)
北米Model "A9020BE-B" EDITED: 2022/ 5/ 16
CAUTION
. If the engine is stopped during
driving, the catalyst may over-
heat and burn.
. When starting the engine, be sure
to sit in the drivers seat (except
when using the remote engine
start system).
NOTE
. Avoid racing and rapid acceleration
immediately after the engine has
started.
. Until the engine is warmed up suffi-
ciently, the engine speed is maintained
high. The engine speed will gradually
drop as the engine warms up.
. On rare occasions, it may be difficult
to start the engine depending on the
fuel used and the driving condition
(repeated short trips when the engine
is not warmed up sufficiently). In such a
case, it is recommended to switch to a
different brand of fuel.
. On rare occasions, transient knock-
ing may be heard from the engine when
the accelerator is operated rapidly such
as a rapid start-up and a rapid accel-
eration. This is not a malfunction.
. The engine starts more easily when
the headlights, air conditioner and rear
window defogger are turned off.
& Starting Engine
s07bd01
CAUTION
Do not operate the starter motor
continuously for more than 10 sec-
onds. If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
NOTE
. It may be difficult to start the engine
when the battery has been discon-
nected and reconnected (for mainte-
nance or other purposes). This diffi-
culty is caused by the electronically
controlled throttle’s self-diagnosis
function. To overcome it, keep the
ignition switch in the “ON” position
for approximately 10 seconds before
starting the engine.
. Do not shift the select lever while the
starter is cranking.
! MT models
s07bd0101
1. Apply the parking brake.
2. Turn off unnecessary lights and acces-
sories.
3. Depress the clutch pedal to the floor
and shift the shift lever to neutral. Hold the
clutch pedal to the floor while starting the
engine.
4. Turn the ignition switch to the “ON”
position and check the operation of the
warning and indicator lights. Refer to
“Warning and Indicator Lights” P152.
5. Turn the ignition switch to the “START”
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
If the engine does not start, perform the
following procedure.
(1) Turn the ignition switch to the
“LOCK” position and wait for at least
10 seconds. After checking that the
parking brake is applied, turn the
ignition switch to the “START” position
while depressing the accelerator pedal
slightly (approximately a quarter of the
full stroke). Release the accelerator
pedal as soon as the engine starts.
(2) If this fails to start the engine, turn
the ignition switch back to the “LOCK”
position and wait for at least 10
seconds. Then fully depress the accel-
Starting and Stopping the Engine (Models without Push-Button Ignition Switch)
290
Loading ...
Loading ...
Loading ...