Loading ...
Loading ...
Loading ...
(131,1)
北米Model "A9020BE-B" EDITED: 2022/ 5/ 16
system will enter surveillance state.
When the system is in surveillance state,
the security indicator light will then flash
slowly (twice approximately every 2 sec-
onds), indicating that the system has been
armed for surveillance.
NOTE
. The system can be armed even if the
windows and/or moonroof are open.
Always make sure that they are fully
closed before arming the system.
. The 30-second standby time can be
eliminated if you prefer. Have it per-
formed by your SUBARU dealer.
. If any of the following actions is
done during the standby period, the
system will not switch to the surveil-
lance state.
– Doors (including the trunk lid) are
unlocked using the access key fob/
remote transmitter.
– Doors (including the trunk lid) are
unlocked using the keyless access
function (models with “keyless ac-
cess with push-button start sys-
tem”).
– Any door (including the engine
hood) is opened.
– The ignition switch is turned to
the “ON” position (models without
“keyless access with push-button
start system”).
– Push-button ignition switch is
turned to the “ACC” position (mod-
els with “keyless access with push-
button start system”).
& Disarming the System
s02af05
Perform either of the following procedures.
. Briefly press a button (for less than 2
seconds) on the access key fob/remote
transmitter.
. Carry the access key fob and perform
either of the following procedures (models
with “keyless access with push-button
start system”).
– Grip the front door handle.
– Press the trunk opener button.
– Unlock using the PIN code access.
The flashing of the security indicator light
will then change slowly (once approxi-
mately every 3 seconds from twice ap-
proximately every 2 seconds), indicating
that the alarm system has been disarmed.
! Emergency disarming
s02af0501
If you cannot disarm the system using the
access key fob/transmitter (i.e., the trans-
mitter is lost, broken or the transmitter
battery is too weak), you can disarm the
system without using the access key fob/
remote transmitter.
The system can be disarmed if you turn the
ignition switch from the “LOCK”/“OFF”
position to the “ON” position with a
registered key/access key fob.
NOTE
For models with “keyless access with
push-button start system”, if the ac-
cess key fob battery is discharged,
perform the procedure described in
“Switching Power Status” �P403. In
such a case, replace the battery im-
mediately. Refer to “Replacing Battery
of Access Key Fob” �P458.
& Alarm System Setting
s02af11
To change the setting of your vehicle’s
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
“Disarming the System” �P129.
2. Sit in the driver’s seat and shut all
doors, the trunk lid and engine hood.
3. Turn the ignition switch to the “ON”
position.
4. Hold down “
” of the driver’s power
door locking switch, open the driver’s door
within the following 1 second, and wait 10
seconds without releasing the switch. The
setting will then be changed as follows.
– CONTINUED –
Alarm System
129
2
Keys and Doors
Loading ...
Loading ...
Loading ...